AC Failure

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 21, 2007
Threads
78
Messages
865
Location
New York & California
Website
www.rbfilms.com
Well, my truck was sitting for a week at a body shop waiting to get some work done ... which was never done due to some other issue regarding a fuel leak with my truck. I was away in LA and when I came back to pick up ... unpainted ... the AC was blowing very hot air. Oddly enough, it would blow hot for 10 minutes and then suddenly blow called for 30 seconds. It did that twice and then stopped blowing cold even for 30 seconds. I shut it off and parked my truck at my house.

The next morning, I get up and the AC is blowing cold again ... like a champ. The guy at the body shop said it did not sound like the AC was engaging when you put the control to cold. He said there is a module that controls the vents or something that may be bad .... but people I spoke to that know cruisers did not know what he was referring to.

Any ideas what this might be? I am baffled as to why it would not work yesterday and now be working just fine.
 
Could be a few possibilities: is the engine running hot? The expansion block could be on it's way out or possibly an electrical gremlin. When it stops cooling, look to see if the compressor hub is engaged. If it is, then it's more likely to be the expansion block. If it's not, then something is shutting off power to the compressor.
 
OK...stupid question because I am not a mechanic .... I am just an idiot film producer. What is the expansion block? Is it an expensive part of a costly repair?


Could be a few possibilities: is the engine running hot? The expansion block could be on it's way out or possibly an electrical gremlin. When it stops cooling, look to see if the compressor hub is engaged. If it is, then it's more likely to be the expansion block. If it's not, then something is shutting off power to the compressor.
 
First, make sure your compressor is running. Have someone in the car turn off the AC, then with you standing in front looking at the compressor, have them turn it on max cold. You should see the compressor start turning (the pulley is always turning, but you will see that the compressor clutch engage when the AC is turned on). This will normally cycle on and off as the cabin temp comes down.

Next thing to check is whether or not you have sufficient refrigerant charge. There is a sight glass for the refrigerant just above the battery box (driver's side) against the fender wall. With the AC running and set to cold, you should see a clear sight glass or slight bubbles going thru it when the compressor is running. Note that when the compressor kicks on and off, you will also see a lot of bubbles under normal conditions. If you don't see a clear sight glass, you may have low refrig charge which will cause the low pressure cutoff to engage, shutting down the AC to prevent damage to it.

Both of these checks can be done in about two minutes.

If both of these are okay, then I'd next check your engine temp to see if you're overheating. Don't trust the factory gauge...when running at normal temp, it will show just a hair below the midpoint, but if it's only slightly higher than this on the gauge, it may be running hot, and the system will cut off your AC to prevent the truck from overheating further. The cutoff is at 226*F. Raventai has posted a temp gauge mod that provides more linear temp readings, but if you haven't done that mod, or don't want to, you'll need to either get another temp gauge, or a scanner capable of reading the engine temp directly from the ECU/sensor.

If you're not overheating at this point, it could be a number of things given the intermittent nature of your problem. If you don't have a set of manifold gauges and/or don't want to learn AC repair on the fly (and having to purchase a number of tools), I'd suggest taking it to an AC shop to have them diagnose it for you. It could be the expansion valve as the previous poster suggested, but that's just one of several items it could be. To be more helpful, I think we'll need to know the answers to the above questions first.
 
The operator error that lost database wiped out my posts to each of the individual threads so I am posting here again to sum it up. I just wanted to say that Rick & Nat came through big time and drove 5 hours each way twice to fix the issues with my truck. It turned out to be a defective radio for the batteries, a faulty Crimp on a PS Hose, and a loose connection for the AC Issue. They did a terrific job and went out of their way to get my truck back up and running. These guys are the greatest...!!
 
something similar happened to me on the drive from Texas to Colo (quit blowing cold, went to blowing hot around Pueblo, CO, got it serviced which DIDN'T work). made it to aspen just as my radiator went out. I thought that i would have to fix radiator AND A/C, but mechanic said when the car detects overheating, it will shut down the A/C. Got radiator replaced and A/C works great now. $700
 
Back
Top Bottom