The plastic or nylon cap that goes over the magnet end of the rear ABS sensor fell off when I was cleaning it.
It looks to just keep the magnet from plugging up with shavings.
Should I drive it with the cap off and ABS turned on? Does it need to be reattached before I turn on the ABS again?
I am going to make a run to Denver from Grand Junction over the snow covered mountains tomorrow and would like to have ABS.
What would work to reattach the the cap to the sensor?
It looks to just keep the magnet from plugging up with shavings.
Should I drive it with the cap off and ABS turned on? Does it need to be reattached before I turn on the ABS again?
I am going to make a run to Denver from Grand Junction over the snow covered mountains tomorrow and would like to have ABS.
What would work to reattach the the cap to the sensor?