ABS QUESTIONS

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Rivman1243

SILVER Star
Joined
Feb 27, 2016
Threads
16
Messages
757
Location
Helena Montana
I've read a few threads on deleting the abs and I'm wondering if the change of the circumference of the tires is what's causing the abs delete to be so effective in decreasing stopping distances. Or if lifted vehicles are more prone to nose dive causing the abs decelerometer to respond differently than a stock height vehicle. The abs system I a 3 modulator setup with 4 wheel speed sensors and the decelerometer.

Or are the abs pump/modules leaking internally causing a loss in pressure to the calipers. It's clear that the brakes can physically stop an 80. The foundation is fine. What is really going on with these brake systems?

My 92 Subaru SVX's abs system works excellent. so an old system can work well. Im not trying to say im comparing apples to apples here but there's got to be something everyone is missing here.

What are people's thoughts?
 
To me it looks like the abs delete is making a big difference to trucks with a lot of extra weight and larger tyres on stock brakes.

Would some high performance discs and pads be a better option?
 
I think the stock 80 brake setup will work. People say that with the abs delete they can lock 35's up on pavement.

My Cruiser has a fairly good stink bug stance going on abs I had to max out the lspv to get what felt like any rear brakes. I also had to flush about 3 quarts of fluid through to get clean fluid for more than a few days. Next I went out to a dirt/gravel road and worked the crap out of the abs and bled the brakes again. A few days later I repeated the abs workout and bled again.

I need to replace the rubber lines since they're original. I've been thinking about getting some coil spacers and seeing what effect that might have on the brakes.

Part of the reason I bring all of this up is I don't like driving on ice without abs. I learned to drive without abs but on ice covered roads it's nice. I'm also not the only one who drives my Cruiser.

I also think the Land Cruiser community is missing something when it comes to these 80s
 
I had unknown service history on my truck when I bought it (3rd owner). I bled the brakes, cycled the ABS on soft ground, bled the brakes, cycled the ABS, bled the brakes, cycled the ABS, bled the brakes, etc... The stopping power was marginal at best after the repeated bleeding. All the calipers were rebuilt, purge valves were cleaned, lines drained from what looked like a black mess till they ran clear, LSPV replaced and adjusted per FSM.

I deleted the ABS and couldn't be happier. That being said, I am the only one who drives the truck and I learned with out ABS. I did not put in the manual proportioning valve and the rear can and will lock up on ice. I may install a manual valve in the future to address the ice issue. May...
 
I have always wondered about tire size affecting the ABS system. Maybe someone with more knowledge or experience can chime in on this. The sprockets on each hub that are read by the magnets are clearly always going to be a fixed size. They are set up for factory tires. Once larger tires are put on the speedo reads slower. Is the difference in speed not really noticeable to the ABS system or could mounting larger tires have an impact on stopping because the ABS system "thinks" the 80 is running slower?
 
That's a really good question, I've been thinking about that same thing
 
Back
Top Bottom