AA Motor mount for V-8

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 18, 2006
Threads
37
Messages
455
Location
New Hampster
I have a question for anyone who has used an Advanced Adaptors conversion for a Bowtie V-8 install. In my 40, I bought it without the motor, but I have all the parts. With the mounts for the motor, there is a long one and a short one. My question is which goes on the drivers side and which goes on the passenger side?

Thanks!

Pete
 
If I understand the question right the long mount will likely be on the passenger side and the short one will go on the drivers side. Is this the type of mount you are talking about?

Bret
MMPass.webp
 
Bret said:
If I understand the question right the long mount will likely be on the passenger side and the short one will go on the drivers side. Is this the type of mount you are talking about?

Bret

Yes that is the one. So the motor is shifted slightly to the drivers side.

THanks.

Pete
 
yes it is normaly mounted about an inch to the drivers side to give driveline clearance. especialy with an auto tranny.

did you try a search ? it has been talked about a few times that i remember and the off set was discused in a recent post not to long ago with pics too i think.
 
fj40_rico said:
Not sure if you are but I would recommend not welding those until you have the motor. because you might have to move them forward or backwards depending on spacing.

- Rico.

Already done. the PO converted it years ago. I just need to put a new motor in.
 
bandy rooster said:
i got my AA mounts in and I fawking hate them

I used the AA mounts and had no problems with them. There was a lot of measuring before I welded them but the worked fine.

I know that someone in pirate was fabing som that just slipped on the frame and you bolt them down and they were pretty slick but I sure you can find them with a search.

- Rico.
 
Back
Top Bottom