'94 ABS/Locker issue

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 15, 2007
Threads
89
Messages
478
Location
30°54'01.53N / 84°04'56.04W
I replaced my front axles with Nitro Chromoly. Ever since then the ABS light was intermittent ( I was told the toning rings dont line up exactly)...my lockers were just as intermittent. Now, the ABS lights stays on full time, and my lockers wont engage. I assume its because the ABS system is a permissive to the lockers engaging.
Has anyone tried just hard wiring the lockers to a toggle on the dash and completely just bypassed the whole 4L and ABS permissive system?

Seems to me, they are electric...so it should be as simple as on/off?

If anyone has schematics for the electrical system, and is willing to share, I would be eternally grateful.

Any advise would be greatly appreciated!
 
FSM and EWD are downloadable here on Mud, I'll try to find the link for you.
Thank you Bax454! Now if I could just get some feedback on the lockers vs ABS light. :-) I cant be the only person to have this issue. Or if the lockers can just be hard wired to a rocker switch.
 
Have you pulled ABS fuse?
Do you have CDL button installed and Pin#7 mod? Turn that on. Does the center lock up with orange light on dash? Flash or full on?
Red Front and Rear locker lights flashing at least?
Put TC in low range and try?

no expert here....
The e-lockers aren't as easy as a On or Off. The (4x4) modules check for certain states, L range (or CDL button) and.. etc. The the actuator the drives the pin in (for x amount of time or to its extended length or something) then stops. Same for when you unlock is powers/drives the pin out and stops. However, before looking at the elec wiring diag, I would think you could push/toggle button mod it and drive it in drive it out.

Convert to cable lockers? :)
 
Well this is embarrassing. I talked to the former owner and we talked about it...Its been so long since I have had this thing out because of the ABS light on and lockers not working, I had completely forgot that the previous owner had installed the CDL switch, but used a hazard switch...
As soon as I removed the ABS fuse, engaged the CDL, I was able to engage both lockers. I feel like a complete baboon. Been driving LC's for 10 years and just FORGOT about the CDL.
I so very much appreciate your assistance!
 
Back
Top Bottom