'92 Overheating issues

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 20, 2007
Threads
115
Messages
593
Location
Provo, Utah
I am having some issues with my '92 3FE FJ80. After 15-20 miles of freeway driving my coolant is boiling (literally). I just changed the hoses and thermostat with Toyota parts and put a new fan clutch on. I don't have a radiator shroud (the old one was shattered). My temp. gauge never goes much above half. I know a 50/50 mix of antifreeze will boil at 265* but I have a hard time seeing how the truck could have gotten that hot. Any ideas? I ordered a waterpump from Toyota and will be flushing the system and refilling, verifying that it is a true 50/50 mix. Think my temp. switch is bad? Fan clutch? Any help or advice at all would be appreciated. Thank you.
 
Don't overlook the cap. It is important too. Hope you get it figured out!
 
I would like to get a new shroud, but my cruiser was in a front-end collision before I bought it and a few parts were left off their "restore." Not to mention the fact that everything is crumpled in an interesting manner that does not facilitate the addition of any straight parts from the firewall forward.
 
You need the radiator shroud. If your truck is crooked then either straighten it or fabricate your own shroud. Without the shroud, your truck will overheat which could destroy your engine.

-B-
 
The fan shroud should only be important in city driving. On the highway, the fan dosn't do much. I don't intend to insult you, but we all make mistakes. Are you sure you put the thermostat in the right way? If it's in backwards it won't pass any water at all.
 
Use parts from Autozone on my cruiser? Haha. No way. I have seen too many failures on too many parts to go with anything but genuine Toyota, even if it costs a little more. Thermostat and everything I have put on the beast has come straight from Mr. T.
 
Good to hear, takes some doubt out of the situation. I'm gonna go ahead and disagree with all those assuming your fan shroud, or lack of, is causing this issue.

Flush your cooling system, get one of those prestone kits that puts a T with a hose bib on one of your heater lines, flush as long as you can. Re-fill with a good summer ratio of coolant (50/50 IS NOT IDEAL, it's a compromise...30/70 for summer, 60/40 for winter is better in most areas of the US).

Also, I suggest you grab one a live gauge so you can accurately monitor temps. Then you can see where the issue starts, and maybe you'll be able to notice some patterns in your overheating.
 
Back
Top Bottom