92 Land Cruiser

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

did you try rocky mountain imports on vancouver island? radd cruisers? max overdrive in richmond? from what i remember there were different (smaller?) rotors for the earlier jdms and i think nadm's as well...

Yup that is the problem I am running into. All the rotors they are bringing in are to big.

I live on the Island. Would you have a number for rocky mountain imports?
 
You could talk to mot from here and see if he could send you some straight from Japan... it would be pricey most likely
 
Wait a minute...No fair. My U.S. Made 92 has DRUMS on the Rear....Where are you from ?? Is this a trick question ???
 
Nope that is the problem. This is a off shore cruiser and the North American cruisers never went to disc until 93. They are a bigger rotor though.

I did google Rocky mountain imports and they have the rotor and it is on the way.:bounce: Thanks for all the help this site is awesome.

Another question? I get alot of black smoke out of it. Is this the norm or is there a easy fix?
 
I would take most of the "help" you get for JDM models from the US guys with a grain of salt, IE:
Wait a minute...No fair. My U.S. Made 92 has DRUMS on the Rear....Where are you from ?? Is this a trick question ???

Otherwise any of the JDM parts sources already listed should have no problem getting you the correct rotors, cut and paste from another post (Search function is your friend):

Post 8/92 production Pads will work, rotors will not.

Both the front and rear discs on 90 to ~8/92 JDM 81's were smaller than the ones used post ~8/92 in both the US and JDM models.

The front rotors went from 286mm OD and 25mm thick to 311mm OD and 32mm thick which is the same as the US market trucks.

Rear rotors went from 312mm OD and 18mm thick to 336mm OD and 18mm thick, the post 8/92 rear rotors are the same as the US market ones while pre 8/92 the US market rear brakes were drums.

Front and rear pads are the same for F&R disc braked trucks for 1990-1997, rear calipers should be the same as well with the rear axle to caliper mounts being different.

Pre ~8/92 front rotor on top, post ~8/92 front rotor on the bottom.
AX6.JPG
 
I would take most of the "help" you get for JDM models from the US guys with a grain of salt, IE:

Jeez, I was just joking with you canadiens...I just wish mine had rear disks and some of the jdm goodies that other folks get to use...
 
JDM = Japanese Domestic Market.

Now as far as the black smoke goes... With my limited knowledge of diesel engines, black smoke is unburned fuel.

On another, slightly related topic, have you seen what U.S. guys do to diesels?

Erik%20Smoke.jpg
 
Last edited:
I'm not sure, to be frank. Post in the diesel section about the black smoke, you'll get more relevant help there. :D
 
Back
Top Bottom