91Fj brake question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 27, 2006
Threads
70
Messages
589
Location
muuuuuud
these are the things that I have replaced so far, Break shoe's,wheel cylinder's,master cylinder, calipers(about 2 years ago) I have this weird movement with the brake pedal and it only does it once in a while. I press the pedal when I come to a stop then all of the sudden it drops down about 2-3 inches I never once lose the brakes it just drops and it is not a soft drop it is very fast like something disconnected the brake pedal for a second. All the parts are oem fyi. It has been this way off and on for about a year now.

Thanks
 
If youre not actually losing brake pressure then it isn't a huge problem but I would start with bleeding the brakes


these are the things that I have replaced so far, Break shoe's,wheel cylinder's,master cylinder, calipers(about 2 years ago) I have this weird movement with the brake pedal and it only does it once in a while. I press the pedal when I come to a stop then all of the sudden it drops down about 2-3 inches I never once lose the brakes it just drops and it is not a soft drop it is very fast like something disconnected the brake pedal for a second. All the parts are oem fyi. It has been this way off and on for about a year now.

Thanks
 
Always start with bleeding...cause its free for one thing. That is a wierd problem though.
 
With the engine off, step on the brake pedal, if the pedal goes down, may want to look into the brake booster, (the big round thing behind the master cylinder):D
 
The pedal does not go down when the truck is off it stays very firm. It only seem to happen when I press the pedal down hard when the engine is running.
 
had the same problem. Did you use an Genuine Toyota Master cylinder? I had 3 of those Car quest junk ones put on and they didn't take. Bleed and see if there is air in the line, if not its definably the master c.
 
Was the MC bled? Looks like there is air in the system.
 
The master cylinder was bleed many times & the pedal has a very firm feel to it, it just all the sudden the pedal drops a few inches with out losing any kind of breaking capability.
 
How are your rotors and front pads? What about your rear wheel drums? This could be your brake booster, air in the lines, a freezing wheel cylinder or caliper, a sticking pad or shoe, a warped rotor or out of round drum. You also still have the worthless LSPV system with 8 ft of excess line for air to wreck havoc in. How are you wheel bearings? Spindles? Etc. What about your brake booster?
 
rotors are new pads are new, rear wheel drums I have not replaced. What is the alternative for replacing the lspv? I rebuilt the front end about 10k ago. Brake booster I assume is original.
 
Last edited:
a motive pressure bleeder would make the bleeding process a whole lot easier.
 
Back
Top Bottom