80 Series - Advice

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 20, 2018
Threads
1
Messages
3
Location
Australia
Hey everyone

I have a 1997 petrol LC 80 series. Full-time 4x4. Auto Box.

Recently a set of manual locking hubs were installed to the front wheels. To keep the drive to the rear wheels I was told by a friend to have the centre diff lock switched on. He also said, if the front hubs are locked then switch off the centre diff lock (switching it on only in off-road conditions if the centre lock is required).

Another friend has said it is not good to keep the centre diff lock on all the time even when the front hubs are free.

Bit confused.

What are your thoughts on this?

Thanks in advance for your replies.

Cheers.
 
what happens when you have the hubs unlocked and the centre diff unlocked?

does the car move in drive?
 
@junior80 When the front hubs are unlocked and the centre diff is off, there is no drive because the tranny sends all the power to the front. When I lock the centre diff, then there is power to the rear wheels. My problem is, some say this is ok and others have said it is not good to drive with the centre diff lock engaged.
Bit confused :(
 
it is ok to drive with the cdl on, thts what some guys will do to imp home after braking something in the front axle. I know on other Toyota trucks when the cdl is on you are limited on your speed limit to 62 mph or 100kmh, not sure if that applies to the lc

might be worth while in looking into doing a part tie conversion and removing the cdl in the t-case, with the manual hubs your mostly there.
 
@junior80 When the front hubs are unlocked and the centre diff is off, there is no drive because the tranny sends all the power to the front. When I lock the centre diff, then there is power to the rear wheels. My problem is, some say this is ok and others have said it is not good to drive with the centre diff lock engaged.
Bit confused :(

ok, sounds like you will need to do a part time conversion for the transfer case if this is how you will be using the cruiser all the time.
 
The downside of running with the hubs unlocked and the CDL locked is that the front output of the transfer, front driveshaft, front diff and axle still stays engaged. That might not be good for a long time solution. With a part time conversion that is eliminated. With that conversion the CDL is not removed but it's function changes, switching the front output of the transfer case off and on.
 
Recently a set of manual locking hubs were installed to the front wheels

Why? Why install manual hubs if you're not going to convert the transfer case to part-time 4wd?

Lokka sells "TOY-FO-917" part time conversion kit, with hubs (maybe they'd discount it if you're providing your own hubs) for $388 USD, shipped.
 
Spoke to Marks 4WD in Melbourne. They have the conversion kit for A$325. Think I will get this and have it installed.
 
Back
Top Bottom