80 front bumper repair

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 1, 2008
Threads
70
Messages
869
Location
the CV; miss the CZ
Not to ruin a sale, but to help anyone if saving money is important:
Depending on what condition your front bumper is in, you might be able to do what I did with mine.
First photo shows the sad shape it was in when I bought the 80. Yes, it's the same exact bumper in the other photos.
Some "tools" I used: a hammer, a towel, a jack, a depression in the ground and some paint. Oh, and a vise for straightening the rear brackets.
(That's wash water on the bumper in the second photo and just water under my 80 in the third photo - not a leak)

I plan on eventually replacing this bumper, so this is fine for now.
DSCN2266a.webp
DSCN2996a.webp
DSCN2705b.webp
 
I decided to post this only because someone on MUD stated that they were told by a shop person that their bumper was not fixable.
I did this repair without expensive shop tools - or any body work experience.
Thanks!
 
nice job.!!! did the same [almost] to my 97 lx450..it did'nt come out as well as yours but it will do until a winch bumper and dual battery set up. did you replace the filler pannel ? and roll out the fender
 
Thanks! I have to admit, I really didn't know how I was going to fix the bumper.
Then while washing it out back one day, I noticed a depression in the grass next to one of the tires - that gave me the brainstorm I needed.
OH, I almost forgot, I also used a tree stump, a chain and homemade wooden cross bar for pulling out the center section first before laying it in the depression on the ground and rolling a front tire back and forth over it (I first removed everything from the bumper).
So I used the weight of the 80 itself as a tool.
I would like to replace the lower panel (anyone have a white one available?) or massage it some more. I know it's doable, I just haven't gotten around to it.
For the fender, I left it in place and just worked on it from behind with a rubber mallet. I can better deal with the remaining slight dimple if I remove the bumper. One of these days...
Thanks again.
 
Back
Top Bottom