79 FJ 40 parts. Top, ambulance doors, 2F etc

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

K

kfrosty

Joined
Jun 5, 2006
Threads
24
Messages
80
Location
United States
hello,

I sold an fj 40 chasis and have some parts left over. Really like to sell them all together to somebody that can pick them up. Putting prices for each individually. But open to offers.

1) Top with glass in it. Around the lower edges on the rear there is some rust pitting. $350

2) Set of ambulance doors that mate with the top. Need the 1/4 skins for the bottom. $250

3) 2F engine without a head. Have intake manifold, valve cover and may be able to obtain a head. $250

4) Hood. It's in good shape but appears somebody previously put filler in a section on the top? Not in the front edges where they normally rust. $200

I think I have an extra water pump, possible a radiator fan laying around that I would throw in as well. I'm right outside Charlotte, NC in York, SC.

Anybody near by that has an interest in everything, please feel free to contact me and I can get you pix and make you a good deal on everything.

704-271-3120

kris
 
Update:

The ambulance doors have rust around in the center that would need to be cut and plated. Dropping these to $200.

5) Forgot to list Factory Roll Bar $175

I have pix for everything, if interested please call. Note, I don't check my private messages on this site all that often.

Thanks.
 
Sorry but I can't post pix. You can email me at kkfrost at hotmaildotcom and I'll be glad to send pix of the hood.

I'm approx 20 miles south of charlotte, NC
 
P.S.S I also have a rolling chasis from a 1980 FJ 40. I bought it to build a buggy but from research, appears I need to go with Dana 60 axles.

So I have set of axles, springs, steering bars up front. The firewall is still on the vehicle. I haven't thoroughly inspected the firewall but I think it could be used with a 3/4 tub.

The axles would need to be cleaned. Not sure what these are worth but I'll put a price of $400 on here and open to offers. I wouldn't be interested in shipping these. The frame is pretty rusty, (No rust through) and I'd prefer somebody could could come by and to where I can just take my plasma cutter plasma cutter to it.

If anybody has any Dana 60 axles within close proximity, I'd be open to doing some trading.

Also, as mentioned if somebody has a need for everything I'll definitely do better on pricing for everything as a package deal.

Basically all I'm trying to do is get rid of it and come up with a little scratch to put toward my other project.
 
Is the firewall still available from the '80 FJ40? Don't you also have an un-assembled '79 FJ-40 too?

Might still be interested...

Thanks,
Drew

drewporta@lycos.com
 
You must log in or register to reply here.

Share this page

Back
Top Bottom