77 FJ40 Ignition question.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 28, 2011
Threads
1
Messages
3
Hi gang.
I'm a newbie here. I am just finishing up my restoration on a 77 FJ40 and have an issue with the ignition. The original distributor has been replaced by a DUI unit. The engine runs and performs really well but has an issue during starting. The engine spins over normally when I turn the key. However, the engine will not fire while the key is turned to start. As soon as I release the key the engine fires and starts on the first try most of the time. If I hold the key in the start position the engine continues to spin but will not fire until I release the key.
Has anyone had this issue?

Thanks,
photo.JPG
 
Sure sounds like there is something in the ignition switch causing this
 
The 77 has a ballast resistor and a ballast bypass terminal from the starter. The bypass terminal supplies a full 12V to the coil/ignitor/HEI when the engine is cranking.

How has the bypass been wired to the HEI? How many volts is the HEI receiving during cranking?
 
Thanks for the suggestions guys. Jim, I think you may have the answer. I didn't have this issue with the old distributor. I will take a look at how the DUI unit is wired.


Thanks Again,

John O.
 
Okay Jim...

What's the value of the resister? 12V in and ? out. Is it 8? 6? I'm going to place a new unit in the system.
 
should be 12v in and around 6v out
 
Okay Jim...
What's the value of the resister?

Typical ballast resistor is 1.5ohms. Dunno what the OE Denso resistor is, but if you need that info I can measure one next time I'm in the shop.
 
This doesn't sound right to me. If he has a DUI dizzy, he doesn't need the ballast at all (assuming he has done away with the OEM coil, igniter etc). The dizzy is looking for 12 volts at all times. The fact that the engine starts when he releases the key means that the dizzy isn't getting 12 volts UNTIL the key goes back to the Run position. This implies that whomever wired the dizzy or the ignition got a wire in the wrong place, or he already has a ballast wired in the circuit to the dizzy when he should not have it in the circuit at all.
 
Back
Top Bottom