55 Tailgate issues

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 27, 2005
Threads
2
Messages
10
I'm fairly new to my 72 FJ55. Finally got her running and on the road. I would really like to use the rear tailgate, however the handle is shot. Am I screwed, or can I get it open from the inside? I looked at taking out the window regulator to try and open it from the inside but I can't figure out how to remove the glass. Can someone help me out?:confused:
 
I have an electric type tailgate so i can help a little.
unfortunately you won't be able to remove the glass without first lowering it, your best bet is to take off the cover and find some way of lowering it, my book doesn't show much for the manual type tailgate. perhaps you could unbolt the regulator assembly from the inside while the glass is up, but this will only gain a few inches, if any, and may not prove to do much. have you tried squirting all the mechanisms with WD40/CRC?. If memory serves me right the mechanisms for manual and electric window are quite similar or excately the same, just one has a motor and the other does not, so faulty parts might be aquired from electric type mechanisms, but i'm sure someone will correct me there if i am wrong.

Good luck, hope you get it sorted.

:beer: Daniel
 
The window works, not great but with a little encouragement it'll go up and down. It's the tailgate handle that's broke and won't open.
 
About three years ago (could be more) I had the same problem. Since my handle was in two pieces, I removed the cover (from inside the cargo area) to the tailgate, and then unbolted the handle. I don't remember the part number, but I was able to order a new one from Toyota and installed it. Tailgate now opens.
 
Thanks. But that still leaves with trying to get the window and regulator out of the way to get to the handle. I can't seam to figure out how to seperate the glass from the regulator, so that I can remove the regulator.
 
The handle are available as reproductions (or maybe still OEM replacements?) from SOR. I replaced mine because it broke, also.

It's not necessary to remove the glass, I did mine by removing the rear cover, moving the glass up to the top and propping it up with a couple of cut-to-length wood blocks on either side , then un-bolting the regulator and removing it. It's tricky, but I did it SEVERAL times before I learned my plastic drive gear was bad.

While you're there, check the drive gear in the motor assembly for wear or a major crack, which causes it to bind and not go UP (it will DROP with a crack, because there is no real load on the gear then).
 
Back
Top Bottom