4Lo blowing diff fuse.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 8, 2013
Threads
14
Messages
73
Location
SoCAL
Hi, I was so happy that I finally got my center diff locking. On the dash the light turns on and the abs. However as soon as I start the engine and shift to 4Lo then to drive the diff fuse pops. I could hear the relay clicking a lot. Any ideas how to fix this? I sourced out a used trans relay box and swapped it. It is still the same.
 
check the wiring between the box and the tcase? or between the box and the switch . . .
 
That's the best i can imagine. That or the actuator on the tcase (which contains the diff lock for the center diff) is shorted out.
 
I could hear the motor whirring when the engine is not running and i have ignition on and the 4lo shifted. It sound like it is engaging.
 
If you look at the fuse block beside the steering column. On the cover if would say diff. Its a 30 amp fuse. Mine blew, so i replaced it. With the key on I shifted to 4lo and the actuator whirred the center diff lock indicator and abs lights went up.
 
Update! to the Guru's I need expert advise!

Before the fuse blows, I can hear the relay chatter on the left kickpanel. This led me to believe maybe the relay was bad. Changed the relay, same problem. Then, I tried engaging the CDL with the engine OFF, Ignition ON, it seems to be working the CDL light comes on and the ABS. But once I put the lever to drive I could hear the relay chatter again. I could drive like this and eventually the Diff fuse would pop.

I'm thinking that if there is load (when lever is on drive) the motor draws more current blowing the fuse. I was able to source a known working CDL motor and swap it. Still the same problem.

My question: is there anything else I could check?

If the relay is chattering, does that mean either the (+) or Ground is not holding? I was thinking it is not energized enough to switch?

I don't think it is a short on the circuit otherwise as soon as I engage the CDL it should pop? Thoughts?
 
Mine is doing the something similar. Ever since I installed the CDL switch, and I engage the CDL, it would blow a fuse. It didn't matter if I was in 4Hi or 4Lo. I read somewhere, in the Mud forums, that the culprit is the AC clutch. When AC is running, and you engage the CDL, it blows the fuse. The member who posted the problem replaced his AC clutch, and the problem went away. I've been testing the theory, and sure enough, when I don't have the AC on, and I engage the CDL, the fuse doesn't blow. I carry a box of extra fuses just in case.
 
UPDATE!

Finally figured out the problem. I studied the CDL wiring diagram carefully, and the 5 wires that come up from the CDL motor are as follows: (2) wires for the motor (2) wires for the relay (1) wire constant ground. The wires connected to the relay was shorted somewhere and it is sending a ground causing the relay to chatter. We knew this, because when the relay starts chattering, you could rock the truck side to side and the relay click would follow it consistently. I ended up running new wires from the motor to the transmission relay on the driver side and it works flawlessy now! Thanks for all the help and ideas!
 
Back
Top Bottom