4.88’s, Sliders, OME Heavies, Snorkeled, Locked, York, ARB Bar, Mot’s grab bar

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 18, 2004
Threads
259
Messages
1,501
Location
Pacific Northwest
Location
United States
4.88’s, Sliders, OME Heavies, Snorkeled, Locked, York, ARB Bar, Mot’s grab bar.

The truck starts and moves around it could be fixed but I am selling it as parts. Most likely we will be able to drive it off my trailer and on to yours.

This Cruiser will be delivered to Nogales, AZ in the later part of October. The axles are good and locked. The gears are from Reider Racing. I would like $2,500 for the complete truck with a Washington, State title in hand. I will keep the license plates. Below is the original add before the engine lost oil pressure.

I got her bone stock in 05 from California…After doing research on mud I decided to replace a ton of stuff purchasing everything from Dan at American Toyota. The head gasket was replaced along with everything in between. I built her up as an expedition vehicle….she has a few bumps, along with pin striping due to sage brush. I would rather just keep her……I live in Mexico and the rule is I can only have one imported car. This Cruiser will be delivered to Nogales, AZ for a $1000 deposit to cover some of my travel cost up. The body had/has a full sticker and the panels have glue/dirt.
Replaced:
All hoses both heater/radiator and Vacuum
radiator (1st replacement was a Toyota, 2nd is a no name)
New gas cap
VSV valve
Throttle Cable
Orange and black Vac gizmos
TPS
cap
rotor
gas filter 2x
Gas sock in tank
Gas pump
egr modulator
fusible links
lights for dash(more have gone out since replaceme
rear axle service
Extra Starter with rebuild kits
front abs harness
brake pads 100 series
Brake rotors
door switch sensor
head gasket
thermostat/gasket
water pump
idler pully
phh with silicone hose
timing belt tensioner
PCV valves
Valve stem seals
Rear main
New tie rod ends

Mods I have done:
Corbeau sport seats CORBEAU.COM: Official Site: Seats for Street, Race, Off-Road, and more
Fan clutch with 10k oil per Dan
grab bar
snorkel
Front ARB
4.88 gears
Hand Throttle
cdl
OME 2.5” with Trim packers
 
The truck starts and moves around it could be fixed but I am selling it as parts. Most likely we will be able to drive it off my trailer and on to yours.
I would like $2,500 for the complete truck with a Washington, State title in hand. I will keep the license plates.

where is the truck now? in WA? what happened to it? lost oil pressure? rolled?
 
The cruiser is in Northern Mexico currently sitting out front. I was driving home looked down and watched the oil pressure needle fall. Haven't moved her since.
 
This was taken in January. The York keeps the leaking tires filled.
AA landcruiser for ad pic.webp
 
Just want to clarify I would like to sell this as a whole. Maybe it would be better if I move the thread to vehicles and trailers for sale?
 
Check your PM's.

Very interested!
 
How much for the snorkel? What kind of sliders and how much?
 
On with the pictures.:)

In regards to prices for parts I want to sell the truck whole as stated above $2500 delivered to Nogales, AZ in late October.
IMG_6390(1).webp
IMG_6386(1).webp
IMG_6387(1).webp
 
:doh: my year is up on the silver star... when it gets reactivated I will post up the rest.
IMG_6383(1).webp
IMG_6379(1).webp
 
Interested in trades?
 
Maybe I am not reading carefully, but what's wrong with this truck?
 
Maybe I am not reading carefully, but what's wrong with this truck?

lost oil pressure on the freeway while I was driving home, Have not changed the oil in over a year:idea: the transmission is disconnected and I have been driving it like a manual for the last year.
 
sold.

Thanks mud:clap:
 
Back
Top Bottom