3FE coolant flush

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 18, 2010
Threads
23
Messages
127
Hello, is there a coolant flush procedure specific to the 3FE? About to pick up 2 gallons of OEM red & a few gallons of distilled water. I want to back flush the whole coolant system to remove any deposits.

I know to loosen the petcock & remove engine drain plug, but which hoses should I connect my hose up to to back flush the whole system?

The threads that I've found are on the FZJ80 but want to find it for the FJ80. Pictures are appreciated.

TIA!
 
Bump this thread... i would love to know any specific 3fe information as well.

Thanks,
 
Bump BUMP!! you all know we are still driving our 3FE's right?
 
I just disconnected my lower radiator hose and opened the petcock then flushed the radiator with my garden hose. Then I disconnected the hoses to my heater cores on the firewall and flushed them with the hose and also sprayed some shop air through the heater cores.
 
Hey, I have a 3fe. Nothing to mysterious about a coolant flush on the 3fe.

1) People use a t valve in the heater hose at the fire wall that allows you too connect a hose and flush as much as you want.
2) The block drain cock is on the driver side which will drain the engine block
3) The radiator drain cock is on the you guessed it the radiator
4) I think most people are running green coolant
5) when refilling the coolant run the engine and turn the rear heater on to flush out the rear heater hose
 
Hey, I have a 3fe. Nothing to mysterious about a coolant flush on the 3fe.

1) People use a t valve in the heater hose at the fire wall that allows you too connect a hose and flush as much as you want.
2) The block drain cock is on the driver side which will drain the engine block
3) The radiator drain cock is on the you guessed it the radiator
4) I think most people are running green coolant
5) when refilling the coolant run the engine and turn the rear heater on to flush out the rear heater hose
Awesome!!! Thanks for the input, I will give it a try. I am waiting for an OEM thermostat to come in then it will be time for another flush!!
 
I just flushed my 1fz this month:
1) Set your heater on high (or open your heater control valve).
2) Drain the coolant from the radiator and engine block.
3) Take out the thermostat, and reconnect the pipe to the engine where the thermostat goes.
4) Flush with distilled water, running the engine without the thermostat. (I drained and filled about 4 times. Running the engine until it reached about 120 degrees so I could drain it immediately without having to wait for the water to cool.)
5) Replace thermostat.
6) Fill with coolant.

I used about 15 gallons of distilled water to do a heater core back flush and about 4 drain and fills of the coolant system.

Get a "spill proof" radiator funnel.

This allows you to fill about a half gallon into the funnel while running the engine. When the bubbles stop coming up from the funnel, your coolant system is full. You can also put any extra coolant left in the funnel into the overfill reservoir once you're done.

I have an aftermarket radiator (CSF). And I had to get a thinner o-ring so that the funnel adapter would fit on the radiator with one of the special caps.

Watch how fix it angel uses the funnel on youtube:
 
Back
Top Bottom