2LTE wiring confusion

[yotahed]

My Bro is having an issue retracing his steps on a few wiring connections on his Prado. I can't remember clearly where these wires go. Any help is mucho apprecio.
I'm 800km away from him and my wire loom doesn't exist any more.

Both are on the IP side of the engine bay. First pic the loom near the starter. The 2nd looks very familiar but I can't remember.

Thanks guys

 

[GTSSportCoupe]

I think those might be for the glow system. Probably for the glow rail, and the resistor in the intake manifold. I'll take a look at mine tonight and send a picture if you want. I also have all the schematics for the LJ78, so could look at those too.

 

[yotahed]

Thanks bud. Appreciate it.

 

[HDJDub]

As far as I can remember the ones in the first picture go off the bottom of the intake.

As for the other one I remember one like that maybe being bolted to the fender with a 10mm bolt.

 

[GTSSportCoupe]

As far as I can remember the ones in the first picture go off the bottom of the intake.

As for the other one I remember one like that maybe being bolted to the fender with a 10mm bolt.

I think you are correct HDJDub. The connection on the bottom of the intake is the glow resistor for after glow operation. Yotahed, make sure your bro' gets the spacers right or he'll blow one of the main fuses (been there done that).

Usually GND is brown on Toyotas; so I think HDJDub is right that the third wire (brown) goes to ground somewhere. I forgot to look last night, but will look tonight and figure out where exactly it goes. The glow rail wire looks different (shown blurry in the bottom left of the picture above).

The picture HDJDub posted reminded me of an album, and I have it book marked here: https://www.flickr.com/photos/9842546@N07/sets/72157600724521308/ Lots more pictures there of the wires and other parts of the engine.

 

[yotahed]

Thanks guys. Big help