2F Engine Decision

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

OffRoad Rage

Dry Roasted in the Desert
SILVER Star
Joined
May 22, 2006
Threads
101
Messages
1,011
Location
NW Valley
So, I finally cracked open the freebie 2F I got when I bought my project 40. It is all complete ('77), all the smog equipment is still on it (smog pump is frozen) but there was no oil cap on the valve cover. It sat outside here in AZ for some undermined amout of time. Not much rain but we still get some from time to time. Pictures say it all. And no that isn't tomato soup I was warming in 2 of the cylinders. The head looked OK and there was still oil in the pan. The underside looks OK but I'm going to pulll the bearing tonight to see how they look.

Now what? Do I go through the checks to see if it's rebuildable or should I look at parting it out for what it's worth and find another donor? Ideas?
2F Disassemble shots 001r.webp
2F Disassemble shots 005r.webp
2F Disassemble shots 008r.webp
 
A couple more close ups of the cylinders.
2F Disassemble shots 003r.webp
2F Disassemble shots 004r.webp
 
You won't know until you take it apart.

I've only had to throw out 2 blocks that looked like that.
Above the piston, the bore was surface rusty, but nothing a .020 or .030 cut wouldn't clean up. but when the pistons were removed and the bores cleaned up for inspection, there were deep craters of cavitation corrosion where the aluminum piston had been contacting the iron bore while immersed in water.

OTOH, the block I just tore down last week looked like yours (standing rainwater in #6). after teardown, the cylinders looked bore-able w/ only minor pitting where the pistons had been parked. Seen plenty more that were scary rusty looking, but turned out to be usable w/ a set of .030 pistons.
 
To start off with... what are the inspection specs?? bore and crank dimensions? That will determine how far you can go...
 
To start off with... what are the inspection specs?? bore and crank dimensions? That will determine how far you can go...

And if you're interested to put a good amount of money in this engine!!

I recently rebuilt mine, bore .030 the crank shaft cleaned and a new camshaft, it cost me around 2000$ can, with the gascet kit and a new oil pump!
 
And if you're interested to put a good amount of money in this engine!!

I recently rebuilt mine, bore .030 the crank shaft cleaned and a new camshaft, it cost me around 2000$ can, with the gascet kit and a new oil pump!

So why did you single me out on this? your cost factor is not out of reason.. it takes $$$ to do it correctly....
 
I built up a 77 2F that also had been sitting in the AZ sun for a couple of years. It didn't look that bad on the top side, but I was able to go .010 on both top and bottom.

And, by the way, I agree with you. If you are going to do it right, it costs money. I did everything but the machine work myself, and it still cost me close to $2,000. That included new pistons and cam, and balancing. However, what I have is worth every cent I put into it.
 
Back
Top Bottom