200 series / Tundra FR upper control arm - hoping for crossover of the bolt TQ value

[LINUS]

As stated, I’m about to do a Icon billet upper control arm, and their destructions don’t give the TQ value for that long-shank bolt/nut combo from the factor.

Anybody here done a overhaul & had to pull/re-torque after either a upper ball joint job or going to billet upper arms?

If any of you guys can give up a TQ / ft/# value, it would be awesome.

Purty pleeezeee....

 

[TexAZ]

Contact icon directly. The factory bolt compresses the bushings differently than aftermarket uppers.
If you cant get anything from Icon, the SPC upper arms are probably similar and their instructions are easy to get off their site.