2 piece headers install

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 7, 2005
Threads
288
Messages
4,857
Location
Columbia, SC
I am going to be ordering a set of 2 piece ceramic coated headers from Man-A-Fre next week and I was wondering what all I will need to do this job.

For all of those out there that have been installed, did you replace the bolts or replace them with studs and nuts?

What is the best gasket to use? I am going to paint my intake manifold while it is off.

What is the best way to do this?

Thanks for any help that you might can offer.

Jeremy
 
I have the SOR two-piece and I used two Fel-Pro gaskets, let it warm up to operating temp, then let it cool and retorque, drove it about 20 minutes and let it cool and retorqued, repeated several times until the torque did not change and have had no problems. I would replace the studs...cheap insurance, bolts go only on the ends.

GL

Ed
 
Back
Top Bottom