Lutz Auto
Supporting Vendor
I recently swapped a 1HDFTE into an 80 series. Most of the dash lights can be wire straight to the cluster, but on the late model 1HDFTE ECUs, the cruise light and auto trans 2nd start and pwr light signals are only over multiplex.
I made a circuit board with a microcontroller that reads the multiplex system and sends signals to the lights. If anyone has this issue, there is now a solution. Pretty niche market, I know ha.
I made a circuit board with a microcontroller that reads the multiplex system and sends signals to the lights. If anyone has this issue, there is now a solution. Pretty niche market, I know ha.
1HDFTE Swap Dash Light Interface - CRUISE/PWR/2ND Start | Lutz Auto
The Lutz Auto1HDFTE Dash Light Interface is made to get the multiplex dash lights working on 80 Series 1HDFTE swaps with late model 1HDFTE ECU's. This interface will get the CRUISE light working with all late model 100 series FTE ECU's as well as the PWR and 2ND START lights on the Auto ECU's...
www.lutzauto.com