Greetings fellow cruiser enthusiasts,
I've been searching a bit, but couldn't find a ton of info on the subject at hand. I recently had a machine shop go through a spare 1fzfe head that I will be bolting onto the engine in my cruiser. The head seemed to clean up nicely, not requiring a ton of work, but they did have take .007 off of the mating surface to get a clean/true surface.
Does anyone see this being an issue?
As a data point, at 225k on what seems to be original head and head gasket, I have NOT experienced a HG failure, but I am burning more oil than I am comfortable with. This "fresh" head should remedy that problem, and give me a chance to knock out some other PM while I am in there.
Mike
I've been searching a bit, but couldn't find a ton of info on the subject at hand. I recently had a machine shop go through a spare 1fzfe head that I will be bolting onto the engine in my cruiser. The head seemed to clean up nicely, not requiring a ton of work, but they did have take .007 off of the mating surface to get a clean/true surface.
Does anyone see this being an issue?
As a data point, at 225k on what seems to be original head and head gasket, I have NOT experienced a HG failure, but I am burning more oil than I am comfortable with. This "fresh" head should remedy that problem, and give me a chance to knock out some other PM while I am in there.
Mike