Parting Out 1998 100 series (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

dnp

Supporting Vendor
SILVER Star
Joined
May 2, 2004
Threads
304
Messages
5,944
Location
Jackson, MS
Location
United States
PLEASE PM QUESTIONS / REQUESTS ONLY!

I'm parting out a white 1998 UZJ100 in MS. I'm trying to do this in a more orderly fashion than the FJ62 I parted out in 2017/2018, so I'm going to try to take photos / price parts as I remove them. Whether I'll be successful at that is yet to be seen......

If you don't see what you're needing, check with me. PMing me is the best / quickest way for me to respond, as sometimes the MUD thread software doesn't notify me of a recent response to this thread.

($15 minimum order - it's just hardly worth the effort to pull, package, and ship for less than that.)
All prices are PLUS shipping Note: this truck had some water in it. How much, I don't know, because I don't know where/how it was sitting and/or how high the water got. One VERY important thing I can tell you is that 95% of all of the electrics work. That leads me to believe that at least the interior wasn't that bad, but I have no way of knowing. I'm planning to take a video as confirmation of everything that works, but until I do, here's what I noted:
  • rear vent widows - means switches, harness, and motors work
  • outside rear view mirrors - means switch, harness, and motors work
  • rear locker - means switch, harness, and motors work
  • center diff lock - means switch, harness, and motor works
  • emergency flasher - means switch, harness, and lights work
  • headlights (low and high) - means switch, harness, and lights work
  • turn signals - means switch, harness, and lights work
  • all 4 windows - means switches, regulators, and motors work
  • all four door locks - means switches, and actuators work
  • rear heater blower under driver's seat - means switch, harness, and blower work
  • center vertical console under radio - lights up, but it operates a little "off"
  • Radio - lights up, but I suspect the amp under the passenger's seat failed
  • etc.
All I'm trying to say is, the truck got water, I just don't know how much. I'm going to do my dead level best to accurately describe any part I believe is questionable.

OK, enough of that, let's get started.........

Prices associated with the first photo below (again, all prices are "plus shipping"):

  • Kick panels: $15 each
  • Front seat belt covers: $20 each
  • Lower left dash: $40
  • Cig. lighter console: $20
  • Rear door step pads for 3rd seat: $15 each
  • Rear sill plate: $125 SOLD
  • Driver's door window switch housing $20 SOLD
  • Switch for exterior rear view mirrors $20 SOLD
  • Second row seat center headrest $25 SOLD
  • Mounts for A/C line above radiator $25 SOLD
  • Rear windshield air deflector $275 SOLD
  • Jack $20 SOLD
  • Driver's side subwoofer panel $125 SOLD
  • Tool kit door $15 SOLD
  • Interior roof trim above lift gate $20 SOLD
  • Map light console center section $15 SOLD
  • Glovebox $40 SOLD
  • Lower tailgate $200 SOLD
  • Front headrests $40 each SOLD
  • Rear half of center floor console with cupholder $50 SOLD
  • Spare tire crossmember with hoist $75 SOLD
  • Passenger side rear-most body molding $30 SOLD
  • Center high mounted stop light $55 SOLD
  • Third row seat belts $50 each SOLD
  • Lift gate assembly $475 SOLD
  • Fuel tank skid plate with straps $70 SOLD
  • Floor console inner center section (without DVD player) $40 SOLD
  • Center dash air vents $30 SOLD
  • Tailgate sill plate $125 SOLD
  • Both headlight assemblies $125 each SOLD
  • Brake booster/master cylinder/ABS module (all were VERY sketchy) $100 SOLD
  • Running boards $200 SOLD

Interior plastic parts 1.JPG
 
Last edited:
I need a driver side front door check assembly. Is that something you are willing to remove and ship? If so, what do you want for it? Thanks
 
I need the rear crossmember, can you cut that out? Totally willing to make it worth your while.
 
Hi, how much for the tranny cross member? What shape is it in? Thanks!
I haven't looked at it, but I'm sure it's in good shape. I'll look tomorrow (Saturday) and let you know.

I need a driver side front door check assembly. Is that something you are willing to remove and ship? If so, what do you want for it? Thanks
Let me look at that Saturday to make sure it's in good condition.

I need the rear crossmember, can you cut that out? Totally willing to make it worth your while.
In theory, I'm willing to sell that. Lemme see on Saturday what kind of condition it's in, what it'll take to get it out, ship it, etc. Shouldn't be a big deal......mainly, based on your signature line, I'm interested to talk with you about how much you know about getting a 2UZ into an 80 series! Ha! I'll be in contact.

Left rear outter tail light assembly, left front side view mirror assembly?
I've got both. As above, let me check condition, etc. on Saturday (tomorrow). I always like to check my parts first, rather than just assuming they're OK for reuse.
 
Does the driver lumbar motor work?
The seat motors don't but I forgot to check the lumber. My guess is no.

Steering Wheel, 2nd row headrests?
Steering wheel is there, but it'd need to be recovered. I have the outer 2 headrests, but the center one has been sold. Let me know if you want any of these, and I'll respond with prices.

Thanks.
 
Do you have the pigtail plugs that hook up to the back of the climate control?
I can accept the wires cut, but I do need about a foot of slack.

Photo for reference:
20160901_073428.jpg
 

Users who are viewing this thread

Back
Top Bottom