1975 front brakes

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 28, 2005
Threads
71
Messages
437
Location
spicewood,tx.
the right front wheel locks up when the pedal is pushed. can loosen by adjusting the cylinders, but this just happens again.
took it apart. no obvious problem. question--do these cylinders only have one moving piston (for want of the correct word) ?
if that is the case then i think i have bad hose lines. any knowledge would be appreciated as i don't want to tear apart the cylinders unless i need to. thx jim:beer:
 
Front wheel cylinders are not dual-acting, only single. The adjuster side does not move, only creates a pivot for the shoe.


hope that helps!

-Steve
 
update to whomever might be interested. (is it whoever or whomever?)

some things i discovered and did find in my search.

#1 front cyls. are single as poser said.

#2 rear cyls. are double action.

#3 frt. cyls. are 11/16? didnt look first time and don't want take it apart again--just that they are different than the rears.

#4 rears cyls. are 7/8.

#5 all cyls. are marked r or l. this designates the side it goes on,not the way the adjusting screw turns.

#6 according to the picture i have the adjuster tensioner/flat sping goes to the outside.

#7 to adjust brakes out, go away from axle.

#8 now this where it gets weird. the right cyls. have left hand threads on the adjusters and drivers side have right threads. don't know why this is and maybe my truck is totally messed uppped, but this the only way to make the shoes expand when pulling away from the axle,and the way mine were set up on disassembly.

#9 long shoe springs--frt. goes inside and rear to the outside.

#10 note--there is a ramp on the adjuster . this goes down towardsthe axle centerline-inward. had to redo the fronts once i discovered this..

hope this helps some novice like me

jim.
 
Back
Top Bottom