man a fre

Slightly used Man-A-Fre 2" receiver hitch from my 1987 HJ60. Bolted this to my rig for approximately three months before removing for a restoration. During the work, I purchased a rear frame from SOR which included a welded hitch, so this has been sitting wrapped up in my garage. This hitch...

Searching for 4" or 3" control arm drop brackets. I believe the only outfit that makes them is Man-a-fre but let me know if there is another. shipping to Washington state is a must, unless youre local, then ill pick them up. Thanks, Kenny

Ok Ive currently got SLEE SS brakeline and they have about 4 yrs on them, I got replacement from man A fre along with TREs My question is why are the slee or dorman for that matter so much larger in diameter than the man a fre' anyone use them and have an opinion either way??

I just pulled these drop brackets off my 95 FZJ80. These are a 3" drop. They measure 3 1/8" center to center. I switched to the Slee castor correction plates. There is surface rust but they are fully intact. The bolt is included for each bracket. $180 OBO. For an extra $25 I will sand blast...

Hey guys, new to the forum here, but I've been a lurker for years. Looking to put an aluminum block 5.3 in my 60 with a 4L60E and am therefore selling off my 2f motor and 4 speed transmission. Long block was bought used from Cruiser Parts last summer (15) It had ~120k miles on it and good...

I have a set of 30mm spacers to level out the stink bug on FJ80's. I bought them & was too lazy to ever install em. My loss = your gain. $54 on MAF website I'll take $40 shipped.

This is a brand new still in the box man a fre transmission to transfer case fluid return kit. It is still new in the box I got it from them in. New is $80 from man a fre. Selling for $50 plus shipping. Think it came in a small USPS priority box so shipping would be like 6 bucks. Ended up...