Separate names with a comma.
Hello, I'm looking for a set of FJ-60 door cards in SoCal. The worse looking (cheaper) the better as long as its all there. I'm planning to try...
I have not found a good thread on having a cruise control installed on a stock FJ-60. I had it done with one I owned in the 90's but the company...
My 60 just got a 6BT conversion and I couldn't be happier with it. It required about a 5" lift to fit the Cummins so she sits a little high....
I am just starting to try to re-home my 60, I am not in a hurry to sell. 1986 stock fj60 2F 4spd. Some rust, some small dents. Clean title....
SOLD SOLD I have the fusible link from my 1985 FJ-60. New ones are about $60.00 if you can still find one. I had this as a spare but...
I know some one has some of these in a pile somewhere. I need the black plastic piece, my glass is still intact. Hopefully will find some one...
[ATTACH] Recently picked up an 87 Fj60 from the 2nd owner down here in SoCal with 180k original miles. Just put new heavy OME springs upfront with...
After having my emergency triangles floating around the truck I wanted a good out of the way location but was accessible. I found this mounting...
Since my FJ-60 is now a two seater, I removed the rear seat heater from under the P/S seat. This gave a space for storage. As luck would have it...
Parting out a 1986 FJ60. If you've seen my other listing for "The Great Green Bin LC Parts Sale" - some of these parts may look familiar. However,...
Does anyone know of any caliper manufacturer that makes brand new, as in NOT remanufactured, calipers for an fj60 other than Toyota ?
Posted in July about parting it out...still have lots of parts including Rear axle Engine with 260k (will part out the engine, too) Tranny and...
Parting out my 1986 Toyota Land Cruiser FJ60. Blue exterior and blue interior. Engine has 260k miles and runs good. 4 speed transmission and...
Motor has approx. 188K on it. Runs perfectly, although I have not done any compression testing. As is typical for a 4-speed, it runs at 3K rpm...
After extracting the Toyo motor, tranny & t-case I laid out the Chevy/GMC motor and auto tranny alongside and wonder if I can use the GMC transfer...
I replaced a bunch of parts on my 60 with aftermarket stuff and have some left over parts that I need to get out of my yard. If you see something...
