Interittent Cold Air - Air Conditioner Issue

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 22, 2002
Threads
191
Messages
2,840
Location
Wandering the Wild West
Guys,

I've been reading on here about A/C issues for a few hours now and I haven't quite found anything directly relating to an issue I'm having...

I just picked up a '94 FZJ80 outta Phoenix. When I first test-drove the truck, the A/C wouldn't blow cold. Thought it might just need recharged. Drove the truck again the very next day and the A/C worked like a champ--blowing quite frigid air despite the outside temp of just over 100 degrees. Figured I could deal with it and get it fixed so I bought it and the next day started driving home to Salt Lake City.

Anyway, after about 300 miles of nicely air-conditioned, non-stop highway driving northward from Phoenix, it started raining like crazy on me and the windshield started fogging up. I flipped over to blowing on the windshield and flipped from recirculating air to fresh air. Cleared the fogginess right up. I kept driving like this until after the rain stopped and I noticed it started to get hot inside again so I flipped back to the other vents and went back to recirculating the air. Unfortunately, the air was no longer cold and remained this way for the remainder of the 450 more miles of the journey. Nice and hot, but luckily it was around 6 in the evening at this point and it continued to rain on and off for me.

The next day I drove it to work and the A/C again blew nice and freezing and it did so the following two days. It then cut out on me again, and came back to blowing nice and cold the very next day. It's now been a week of this cycle.

It seems to be relating to when the truck has been driven for about 30 mins or so non-stop and then brought down to idle engine speeds. Today I drove it about 100 miles with no problem, then I hit a stop light and had to sit for a bit and I immediately noticed a different smell...like more of the fresh air smell...and the idle speed dropped to around 500 rpms. I have noticed a sort of click a couple times right when this has happened, but I'm not totally sure I've always heard the click.

edit: oh, i also noticed a small puddle of water under the front right-hand side of the engine the night I got home and again the next time it cut out on me. Nothing from today's trip though... I first thought the rain was the cause, but now not sure. I do understand water drip is normal operation for the A/C, but I'm thinking it was quite a bit too much for this dry Utah climate...

I'm not sure what this could be. Any suggestions? If anybody can search the forum better than me, please post your search keywords or the links...

Also, I'm not against having a pro look at my truck, just not too familiar with A/C shops around here. Any Salt Lake locals have any suggestions on a trusted place to take my Cruiser?

Thanks!

-Ferg-

(sorry this post is so freaking long....)
 
Last edited:
That sounds like it could be the expansion valve icing up, but you need to check some other things first.

Verify fan clutch operation and non overheating status of truck.

verify hub on compressor turning while AC is on but nor working

Look in the sight glass for bubbles or fog or something else, I never did figure this one out so search for sight glass and you'll be overwhelmed with whatever is supposed to be in there.

THEN, if everything checks out, I would order a new expansion valve and AC dryer from the man and have a shop put them in along with a fresh charge. This way, you have a completely fresh system. IIRC the parts aren't too bad.

What seems to be happening to your rig is the expansion valve is icing up due to moisture in the system, however, the other things need to be checked first.

Also, Try running recirc only, AC on constantly with the temp slide about 3/4" from full cold. This works well on my Dad's old camry, but YMMV

Good Luck,
Dan


BTW, Congrats on the new rig!!!!
 
That sounds like it could be the expansion valve icing up, but you need to check some other things first.

Verify fan clutch operation and non overheating status of truck.

Fan is definitely turning and I have had zero issues with the temp of the truck.

verify hub on compressor turning while AC is on but nor working

Compressor was indeed still turning when this happened again.

Look in the sight glass for bubbles or fog or something else, I never did figure this one out so search for sight glass and you'll be overwhelmed with whatever is supposed to be in there.

I did do a search and ya, I have no idea if it's supposed to be bubbly or clear or what... LOL

THEN, if everything checks out, I would order a new expansion valve and AC dryer from the man and have a shop put them in along with a fresh charge. This way, you have a completely fresh system. IIRC the parts aren't too bad.

What seems to be happening to your rig is the expansion valve is icing up due to moisture in the system, however, the other things need to be checked first.

Expansion valve and AC dryer eh? I'm on it. Anything else that anyone can think of that this might be?

Also, Try running recirc only, AC on constantly with the temp slide about 3/4" from full cold. This works well on my Dad's old camry, but YMMV

Good Luck,
Dan


BTW, Congrats on the new rig!!!!

And tried running the AC with the slide a bit over from the end and i still had the issue.

-Ferg-
 
Back
Top Bottom