Real Time Brake question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 4, 2004
Threads
100
Messages
2,574
Location
Tucson AZ
I am looking at my rotors and brakes, and after I removed the DS front tire I noticed the the anti-rattle spring is missing. I know the rig has after market rotors and probably pads.

Is this a big problem. I will see if I can get a new one (two?).

Ross
 
i have 100 series pads and i removed all ati squeal shims, which is necessary to fit the pads in i have no problems no noise at all. not sure if the squeal shims are what your talknig about hope this helps
jerome
 
There are no anti-squeal shims either. The anti-rattle spring attaches to the two pins.

An new question. Do the wear indicators face down or up? I really don't trust how these pads were installed by the PO. I was looking at some OEM pads and I have two L and two R. I will use the search to try and find out also.

EDIT-the wear indicators face down.

Ross
 
Last edited:
Just did my brake job and my shims were missing as well. My spings were there however.
 
GeoRoss said:
There are no anti-squeal shims either. The anti-rattle spring attaches to the two pins.

An new question. Do the wear indicators face down or up? I really don't trust how these pads were installed by the PO. I was looking at some OEM pads and I have two L and two R. I will use the search to try and find out also.

EDIT-the wear indicators face down.

Ross
If you're referring to the spring-steel part that presses against the two holding pins at the end of the caliper, then I would think that part is extremely important. It funtions (at least in part) to apply pressure to those two retaining pins, otherwise, the only thing holding the pins in would be that skimpy wire thing that goes thru the ends of the pins. If that wire thing were to be lost/broken, I imagine it would be easy for those pins to back out over time, and you could loose your pads/brakes.
 
I will replace. Why on earth did the last person who did the brakes leave it off :mad: . Oh well, I'll be visiting the local dealership. I haven't looked at the back yet, but I'll get those replacement parts as well (wear indicators, shims, etc) as they are likely to be missing as well.

Ross
 
GeoRoss said:
I will replace. Why on earth did the last person who did the brakes leave it off :mad: . Oh well, I'll be visiting the local dealership. I haven't looked at the back yet, but I'll get those replacement parts as well (wear indicators, shims, etc) as they are likely to be missing as well.

Ross

Ross,
Those anit-rattle springs can pop off if you hit a pothole at speed. You can get a "brake hardware kit" most anywhere and it should have the anti-rattle spring and the thin wire that secures the pins.

-B-
 
I picked up the anti-rattle spring from the dealership here in Tucson for a bit less than $10. The shims were a bit more.

I hope the back hardware is there as they didn't have them and I didn't want to special order them.

Thanks for the responses.

Ross
 
Problem solved see link
 
Back
Top Bottom