fj40 parts more stuff!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Isotel

Isotel

10 Year 15 Year 20 Year
Joined
Sep 28, 2003
Threads
311
Messages
3,962
Location
Crawlorado.com
Website
www.crawlorado.com
Location
United States
Stuff off my 76 FJ40

Radiator - Needs some fins repaired - FREE
Stock Shocks and Shock Towers - FREE

Battery Tray -$5 SOLD
Cigarette Lighter - $5 SOLD
T-case Shifter - from a 4 speed $15 - SOLD Poser
Rubber Rear Mat one small tear $20
4 Speed Tranny +shifter $100
V8 Butterfly Headers (fender exit) - Thick flange, O2 sensor bung.. $30 Sale Pending khite100
Rear Springs kinda tweeked, ok for a trail rig- $20
Emmissions vent box for Gas tank - $10
OEM Front Tow Hook, and Both Bolts/nuts, (bolts to the frame in the front) $10
Center Pivot for Stock Steering+stabilizer, a TRE, and a clamp for tie rod all used $15
Craig Tape Deck (this was in my cruiser when i bought it, no clue if it works or what) $5
Power Steering Reservoirs 1 from a Toyota van, one from a GM Van $10 each
Jack hold down Bracket (goes under drivers seat) $15 SOLD Poser
Tool Bag hold Down Loop (under driver seat - Rubber loop with brackets) $10 SOLD Poser
Rear Reflectors (pulled from a 78 toyota pickup, No crome ring, but in good shape) $15
OEM lug wrench.. surface rust $10
T-case rear output cover - $5
Gas Tank Cover sheetmetal - $20

ALL Prices OBO (Make me an offer!), and you pay Shipping..
Paypal Accepted

Here are some photos of a bunch of the parts together..
 
Last edited:
I would like..


Tcase shifter from the 4spd...






Jack hold down Bracket (goes under drivers seat) $15

Tool Bag hold Down Loop (under driver seat - Rubber loop with brackets) $10


I need this stuff too...




what is the story on the A/C comp?
 
Last edited:
I'll take the transfercase shifter post from the 4spd

Thx
 
Poser said:
Where is this piece?
"Emmissions vent box for Gas tank - $10"
Click to expand...
Part # 45 below.. "FUEL SEPARATOR"
168a2.gif
 
Poser said:
That is not the correct piece for your application....just fyi....that is from an earlier truck....you need a 08/80 and later pivot.



:beer:
Click to expand...

Ok......never mind...........Thanks Poser.......
 
bump for the newyear, and i updated the list.. Please See the photos, or request a photo if you are unclear of what items i have forsale
 
khite100 - Clean out your PM Box!!​

(my PM to you)
<
The photos are at the top of this thread


They are not in perfect shape, But have no major rust, and they seal up good.. The Flange is pretty thick maybe 3/8" which ive been told is a sign of a quality Header.. id dose have some surface rust, and discoloration from being used over the years..

They Definatly made my cruiser sound like a Stock Car :cool:

Let me know! i am thinking about putting them on e-bay if you decide you don't want them..
Trevor
>
 
You must log in or register to reply here.

Share this page

Back
Top Bottom