transmission and transfer fill ports

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 8, 2004
Threads
261
Messages
5,416
Location
MilkyWay
I feel stupid asking this question but I can't seem to find the transfer filler port? can somebody show me (picture) where it is located?

Cheers....:beer: :beer: :beer:
 
its on the upper side of the transmission on the drivers side you cant miss them they are 17mm.

if you have a skid plate you need to remove it
 
Transfer fill port faces the rear of the truck, about 2" up from the bottom. Transmission fill is high on the driver's side and faces out toward the driver's door.
 
Ok to make sure are these the fills?
P1010127.webp
P1010126.webp
 
Isn't that too low for a fill port? I would expect the fill port on the tranny to be much higher than that.

Then again, I'm a greenhorn as well.
 
What is the purpose of a fill hole on the tranny? Ive always seen/heard of filling the tranny through the dipstick, where is goes straight to the pan. Fluid would have to find a way to drain though the tranny if you filled from the side like that. On a related note, what weight oil is specified for the tcase?

Matt
 
Matt,
On the 60 series with the manual transmission there is no dipstick. The only way to fill a 60 series manual is either to use that fill plug pointed to in the picture or remove the top cover and fill it that way. The use of the dipstick on the automatic transmissions is the correct way to fill the automatics though.
 
Might also add, if you pull the trans plug and it gushes out, remove the transfer plug and it's low, your seal is gone between the two. Many a transfer case died an early death from this. This is the correct fill location for transfer in photo. It runs in an oil bath, not submersion.
 
agent orange said:
What is the purpose of a fill hole on the tranny? Ive always seen/heard of filling the tranny through the dipstick, where is goes straight to the pan. Fluid would have to find a way to drain though the tranny if you filled from the side like that. On a related note, what weight oil is specified for the tcase?

Matt

Gear oil for TRN/TFR: Book says 90W or 80W-90, GL-4 or GL-5. Folks have also been running fancy synthetic 75W-90, GL-4 or GL-5 with no ill effects. I like the GL-4 myself.
 
same as the 40?

With a 4spd 1980 FJ-40, would the fill ports be the same as the picture above? If not could some one point me in the right direction? Tried to search forum and this was the most promising thing I found thus far.

Thanks!
 
Yes they are the same. However, your fill plug is probably the smaller 17mm version. It is however, in the same location.

Dynosoar
 
Thanks Dynosoar!
 
Last edited:
Back
Top Bottom