- Location
- United States
Located in Northumberland, PA 17857
400$ for all the 40 stuff listed
600$ for the 350 V8, SM465, 3-speed cruiser case (core)
I was gathering parts to do something with all this because it is all usable but am going another direction on an FJ-60.
1982 FJ-40
Frame has surface rust, no obvious structural problems
brackets and engine mounts still on it
cowl is good, floors are OK (been patched) rear channel is poor
tub has rust and dents but is workable with replacement metal
stock undertub fuel tank
have two early 70's hard doors in OK shape
fenders are usable, bib (no bezel), hood, turn signals
stock roll bar with pads and belts
pedal bucket
front heater from a '78 and rear heater with copper lines from '78
front and rear 40 axles housing (empty) with surface rust
Grey Supra seats included
long set of rear jump seats in usable shape
no title or VIN plates
windshield frame fair
all the interior stuff is gone from the dash, etc.
no springs available
rear and front bumper are there and good
rear brake light/turn assemblies
no engine, tranny, t-case, drivelines, etc.
4 J6 rims and rollers
driveline stuff:
"core" 3-speed cruiser case, SM 465, good running 350 with new intake and carb, 202 heads
no flywheel or clutch or drivelines available.
Take all this stuff and build a 40 truggy.
I need to pull the 350 from my minitruck but other than that, it is all ready to go...
Pics of the 40.... LINK
400$ for all the 40 stuff listed
600$ for the 350 V8, SM465, 3-speed cruiser case (core)
I was gathering parts to do something with all this because it is all usable but am going another direction on an FJ-60.
1982 FJ-40
Frame has surface rust, no obvious structural problems
brackets and engine mounts still on it
cowl is good, floors are OK (been patched) rear channel is poor
tub has rust and dents but is workable with replacement metal
stock undertub fuel tank
have two early 70's hard doors in OK shape
fenders are usable, bib (no bezel), hood, turn signals
stock roll bar with pads and belts
pedal bucket
front heater from a '78 and rear heater with copper lines from '78
front and rear 40 axles housing (empty) with surface rust
Grey Supra seats included
long set of rear jump seats in usable shape
no title or VIN plates
windshield frame fair
all the interior stuff is gone from the dash, etc.
no springs available
rear and front bumper are there and good
rear brake light/turn assemblies
no engine, tranny, t-case, drivelines, etc.
4 J6 rims and rollers
driveline stuff:
"core" 3-speed cruiser case, SM 465, good running 350 with new intake and carb, 202 heads
no flywheel or clutch or drivelines available.
Take all this stuff and build a 40 truggy.
I need to pull the 350 from my minitruck but other than that, it is all ready to go...
Pics of the 40.... LINK
