Recent content by zed

I ran some trails Friday with 1st gen that had 1" taken off the bottom of the housing and was wondering if it's possible to do to the 80 housings. I do realize anything is relatively possible. But is there enough room below the ring gear to give the 80 housing a flat bottom?

I ran some trails Friday with 1st gen that had 1" taken off the bottom of the housing and was wondering if it's possible to do to the 80 housings. I do realize anything is relatively possible. But is there enough room below the ring gear to give the 80 housing a flat bottom?

It's like a fedora, for your truck.

267k New radiator&wp @235k No head job no valve job. Just got the timing chain cover gasket repair done and no more leaks that I see.... yet. Still burn a quart every 2k it seems though.

1 put a14mil short well socket on the a/c tensioner, loosen. 2 with an extension and 12mil go through the access hole in skid plate. Removal unnecessary. 3 remove belt. 4 loosen lower bolt on alt (above idler) 97-12mil and short extension. 5 loosen 14mil (deep well) on top of alt. 6 loosen...

1 put a14mil short well socket on the a/c tensioner, loosen. 2 with an extension and 12mil go through the access hole in skid plate. Removal unnecessary. 3 remove belt. 4 loosen lower bolt on alt (above idler) 97-12mil and short extension. 5 loosen 14mil (deep well) on top of alt. 6 loosen...