update on 15amp ECU/IGN fuse.
Narrowed short down. If I let truck idle for a while I can hear shift solenoid make noise and then I am able to shift out of park to Drive without stepping on brake pedal and you cannot hear solenoid actuate.
OR
Before solenoid makes noise you can shift from park...
No such devices. Completely unmolested bone stock rig. Got it cheap and its going to cost me a fortune :p. Tr.ying to make it reliable while I work on finding a mercedes 606 to replace 3fe. I am using it as a daily.
Had to divert attention to replacing rear wheel bearing, leaking seals, and...
Thanks for the EWD.
Unplugged Cooling fan ECU/timer turn on power 15amp breaker holds. Started truck and 15amp breaker trips. shut power off, reset breaker turn on power but dont start engine and breaker trips.
unplugged speed sensor turn on power breaker holds, turn on CDL in dash 15amp...
That is correct. fuse panel by left knee. Where is the engine bay cooling fan ecu/timer located? I found it pass side kick panel. Still working on short.
thanks
1992 Fj80 I have an electrical issue could use some help...
Turn ign on 15amp #9 ign/ecu fuse pops
Activate CDL swtch in dash 30 amp #14 Diff fuse pops
Shift lock does not work (have to use bypass button, but will work with new 15amp ign/ecu fuse if you time it right) Disconnected harness to...
Thanks for the reply. CDl was disassembled and cleaned up. I reassembled and now functions correctly. I believe I assembled in the lock position and T-case was in unlock position. I am assuming I can remove actuator and reset it to unlock position and install. This should allow CDL to be...
Center diff lock actuator needs repair, wiring has short. when removing must actuator and transfer case be in locked position or unlocked?
Thanks
1992 FJ80
Bearings were ordered from nitro gear, quality seemed ok. Customer service was terrible. Upon disassembly there only thingthat failed was my ability to set preload. Preload corrected bearings in great shape. Another lesson learned with this rig. Checking driver side preload this morning. I...