So i pulled the AC controller and I put power to pin 6 on the B connector and the Amp relay was clicking, so my circuit was good. I then removed the back of the controller and lifted the top circuit board up and I found this:
Ya think that may be my last problem? LOL
I hope it's the last...
We have three problems. One was that the R134A was low when it came in. I corrected that.
Next was why did I have an open circuit on pin 7? Where the heck was that ECTCR located?
No wonder I couldn't find the dang thing. It wasn't there.
So, now I can put power to pin 7 and the AC clutch...
I am sure that my circuit for pin 5 is good. If you put power to this pin, you will run the starter. Not sure why, but that's what happens. Maybe this is the signal to remove power to the AC clutch when starting?
Correction on the ECTCR terminals. I found in the engine section where it talks about the AC increasing engine idle speed. Terminals 2 and 4 get power from pin 7 on the Amp and terminal 1 is the ground side of the relay through the temp switch and pin 3 is the output to the Clutch and signal to...
I have hot wired the clutch and it works. I have also jumped the pressure switch to no avail.
According to the wiring diagram that I have and the test results from the FSM, here is another version of what I wrote earlier about the AC Amplifier:
Pin 2 - This wire goes to the AC switch and...
Hey there folks. New guy here working on a Buddys 1995 FJZ80 TLC. We did the Hoses - including the PHH (you know it's a common problem when it gains acronym status like a KDP on early Cummins). He also wanted me to look at the A/C system.
First off, I evacuated it and recharged it with a proper...
Hey there folks. New guy here working on a Buddys 1995 FJZ80 TLC. We did the Hoses - including the PHH (you know it's a common problem when it gains acronym status like a KDP on early Cummins). He also wanted me to look at the A/C system.
First off, I evacuated it and recharged it with a proper...