Recent content by watsonbug

Bringing this back from the dead. I've tested my relay and I've got 12v coming in from the white wire but nothing going out the blue. I'm assuming I need to replace the relay which has a part number of 058700-4000 on the rubber cover and was manufactured by denso. Once the rubber cover is...

So if I just had my steering rack replaced last year and had a dobinson lift, new upper control arms, and new cv axles replaced last month...that would be a problem.

Did you get this solved? Mine popped on this morning and went away after a restart but I'm worried they might do it again so I'm trying to be proactive.

3 years later how’s this holding up? I just purchased the same supplies.

Awesome. I'll go pick up some washers as I don't have the tools to cut a steel pipe at my house.

Took a few as I'm not exactly sure what you're looking for

2001 body. 2006 frame I believe. Think I could just some washers instead of making spacers like in that thread?

Large tubular bar at the back is not there. There was a hitch there that I removed to fit the tire. So I need to go find that part somewhere is what you're saying?

no worries. I'll try again tomorrow and I'll try to flip that bar in the picture back around. The previous owner flipped it up to fit a larger tire but never put the tire back down there.

It looks like I have that part right in the last 4-5 seconds of that video above. I'm assuming there isn't a specific bolt hole it's supposed to be in and the flat piece on the opposite end goes against the inside of the wheel across from the bolt hole.

Yup got that.

Potentially a dumb question - I just relocated my spare tire to the stock location after removing my hitch. 33s. It seems to move quite a bit side to side even though it feels like it's as tight as it can go. Could I have put it in there upside down? Any other explanations or is this expected?

Well hell. I quoted the wrong person. @Roody I'm asking for a review of the mod system. Curious about maybe just buying the drawers and mounting them to a frame. Combined they look to be significantly taller than other drawer setup but separate both shorter. Also only rated for 50 lbs on the...

Looking at one of these and you're the only person I've found so far that has any sort of experience with them. What size is this one? Is mounting the drawers directly to the floor without the base an option or just something you did that isn't officially supported?

Hey team, I've had some strange electrical gremlins for going on 2 years. They don't really affect much but I'd still like to get them sorted. My front left headlight burns out if replaced, rather quickly. While it's working my voltage will jump to 16-18 and my battery light will come on...