Recent content by wapitimud

  1. wapitimud

    Torque wrench recommendations in 2025

    Precision has made some torque wrenches for Snap-On in the past too. Great pricing and quality from Precision.
  2. wapitimud

    Torque wrench recommendations in 2025

    CDI is a Snap-On owned company. As is Williams Tool. I would skip anything HF or Gearwrench if you can get the better tool for close to the same price. Skip the tool trucks, especially Matco. If you're doing Matco, you should just do Gearwrench.
  3. wapitimud

    Low compression on 1HZ

    I would offer different advice if it were his father's 1996 Diesel Chevrolet Suburban. I'd say don't bother then. Given that it's nearly a 30 year old truck, its overdue for an internal renewal, which could be minor, or there might be lots wearing, how could I know from here? 317,000km is...
  4. wapitimud

    Low compression on 1HZ

    317,000km on a truck that old. Its not made of magic sauce. It's overdue for a partial rebuild. engine out, pan off, head off, measure cylinders, new rings.. new crank bearings too.. new water pump, new hoses. New clutch and fluids when everything goes back in. It's much cheaper to repair it...
  5. wapitimud

    MESHTASTIC Info or Experience

    A bunch of Meshtastic handheld terminals, like the Lillygo, might work well for a group of a dozen or more campers suffering from smartphone and internet withdrawal symptoms. 😆 You could do far greater range at decent speeds for basic text on 70cm/2m APRS, but all would need to be licensed...
  6. wapitimud

    A good AM/FM aerial for outback Australia

    I might expect you'd only need the AM BCB while stationary at camp. If so, you could affordably buy a long wire dipole, supported by three tall guyed painter poles. Coax going to a reciever, I have a cheap Chinese ATS-20 Si + radio.
  7. wapitimud

    Wanted WTB: good used 1HZ radiator for 2007 HXJ79. AB/BC CAN

    A lead for a new aftermarket alloy radiator would be good too. Thanks.
  8. wapitimud

    Wanted WTB: good used 1HZ radiator for 2007 HXJ79. AB/BC CAN

    Looking for tested, good used radiator for HZJ79. No brackets required. Prefer seller in Canada.
  9. wapitimud

    Land Cruisers Direct Status?

    I've been watching this thread for awhile, and I tried reaching Steve early on when I lost contact as everyone did. I did a deal years ago with Steve, it took plenty of blind trust and commitment on both ends, and the deal worked through. It was very challenging technically, like a moon landing...
  10. wapitimud

    Parting Out 2005 HZJ79 LHD two-door cab dash, interior

    I'm sure I have that bracket. I would sell it off with either the entire steering column or dash. Isn't it an affordable bracket as new part?
  11. wapitimud

    Parting Out 2005 HZJ79 LHD two-door cab dash, interior

    This one will have Ausco mine brakes on OEM Toyota axles, i'm looking to sell those Ausco mine brakes off as well.
  12. wapitimud

    Parting Out 2005 HZJ79 LHD two-door cab dash, interior

    Thanks for dropping that instrument cluster photo on my thread here. I have one I'm selling him already.
  13. wapitimud

    Parting Out 2005 HZJ79 LHD two-door cab dash, interior

    Lots of parts still available. No doors or drivetrains
Back
Top Bottom