Recent content by TowingTriplets

The forum famous man himself! I've been diving into the forums for this platform for awhile now. You mentioned limiting up travel. I plan on ordering perry parts bump stops. Is there another brand you recommend instead to limit up travel. Again I don't plan on doing anything like rock climbing...

Yes I've been through the rabbit hole. But just thought I'd ask for inputs on current setup and future thinking. And thanks for clarifying droop for the e&e offroad spacer. I do plan on building out a drawer system. And slapping on a hitch mounted tire carrier. But I don't think that weight...

That makes more sense. I was honestly in awe. Never seen anyone do past 0 offset

Dude that's an insane amount of offset

Just picked up a 2011 lx. Bought some wheels and tires. Nomad 17in, 0 offset, on 285/75r17 incoming. I've read alot, but want to ask just in case. fender liner rework, bmc and sensor lift will be all that's needed to make that size fit? Planning on the nst spec 1in body lift eventually...

I have been waiting for a solution to this

Hey yall, stupid question I know. But in a total noob. I want to upgrade my fogs. But I don't want diode dynamics. I'm assuming it will fit, since they're similar to the Diode Dynamics. Don't wont to run diode, but I will if these won't fit. I'm a rigid fan boy.

Thank you for the information. A couple of things, how would water ingress into the sunroof if it's siliconed off completely? I'm honestly asking. I did three layers on a dry day. Then tested it afterwards. The truck was southern owned, and no rust, the leak is as recent as 1 month ago. So I...

I'll make sure to try out you all are suggesting. I'll have to pull up the wiring diagram to locate the harness underneath exactly. But that'll have to wait until it isn't raining all day here.

I would never joke about the issues I have with my vehicles. I will admit, the last bit was a joke.

Got it, I just watched a video on a rear bearing replacement. I'll have to watch one for the front. Shoot if that's the case I may as well do a rotor uograde.

Thank you for the information. Learning more and more everyday.

I'll have to dig out my digital voltage meter to check it. And I'll look into the harness. Do you happen to know if it's a lengthy process to pull and replace the harness?

I used outside, weatherproof silicon. Gorilla silicone to be exact. Went over it 3 times, letting each time dry before another layer. I hope it's just the brakes, just have to find time. And if I'm not mistaken, are the bearing the same as birfields on this platform? I'll have to take it in to...

Thank you for chiming in. In assuming beyond the AHC specifics. It was a direct drop in? And did you order the full kit? Or just the front lift? Have some 305/70/17 paired with some +25 offset wheels waiting to be ordered. Planning on a BMC when I eventually make the jump to 37s along with...