See blown fuse pic below. Replaced fuse, drove home, shut off engine, fan runs! Set timer on my phone. At 10 seconds before 20 minutes fan shut off. I won the lottery 🤪
Does make me wonder why it blew in the first place, but I’ll take what I can get for now...
-Tom
PS: My 1980 service manual has this diagram showing relay locations (pic 1). In my 1982 truck though they definitely are not according to this diagram. Some are there, but there is nearly nothing on the passenger side and I don't see all these on the drivers side either.
The schematic below...
I was doing some other work on my 1982 FJ40 and noticed the fan (1st pic), and said to myself: "Self? What is that thing for? Never heard it run...or maybe I did when I first bought the truck, but not for a very long time." Next thing I know most of yesterday disappeared into the rat hole of...
Mcmaster is a good source for high quality foam material for gaskets. I'd buy some adhesive backed EPDM or Buna sheet in the size and thickness needed: McMaster-Carr
-Tom
I don’t think there is a specific part, but would love to be proven wrong. I looked around at the time and I recall only finding “blower refurb kits“ which were overpriced packages of cheap open-cell foam and adhesive backed weather stripping. You even had to cut your own holes in the foam. I...
Yes, it is normal. Mine used to have a black gasket there. Mice decided to chew it and make a home in there. I built my own replacement out of two 1/4” foam laser cut and RTV’d together. That was about 5 years ago.
Nice! I dub that the Corona40. 😀
I was bummed when the models above didn’t make the cut. I have been a bit mad at LEGO ever since. I wish whoever made the originals would put out their own kit, I’d buy one!
My '82 FJ40 passenger window screeches outrageously loudly when rolling down. It is the call of the wild, all traffic comes to a standstill and people turn their gazes in my direction (only a minor exaggeration :-). It only happens when going down, not up. Any guesses why and is there...
Thanks to both of you. I live in Michigan so there isn't any inspection of any kind. But I would like it to be original in general and legal (or easy to make so) if sold elsewhere someday. Sounds like I either disable some stuff or just leave it all intact. Regarding the catalytic converter...
At some point in the future I want to completely de-rust and restore my '82 fj40. When I replaced the exhaust manifold a year ago I was amazed at the number tubes and piping in the engine that I had to disconnect/reconnect. It was quite a puzzle to get them back in the right place. When I read...
The forces created by your adapters on the ends of the lift manufacturer's arms are another potential failure point. The cylinders that receive the pins are welded into the ends of the tube and were intended for a downward vertical force. The new force created by the adapter is a rotational...
The front arms don't reach the frame at all, even the "wide" part. They fall short by about 4-6" per side. In addition, my shopmate's Defender 90 has the same issue and misses by a little bit more...
-Tom