Recent content by Tomba

Speedhut!

That Econoline was one of the cleanest ones i've seen. I recently watched a short of Jay Lenos Garage where a Chevy Corvair Rampside pick up that looks quite similar was featured. Another very cool looking rig. Yeah, too many projects and the stall thing is bound to happen :confused:

I just used one screw for the lens for now...but might see if I can find a small tap this afternoon and see if I can make it a tad better

That may work. I'll need to chase the threads tho as the corrosion was what caused it to break while I was removing to investigate a ground issue. As we know, one project most always leads to....

Sounds like I need to give Ferkel a bath for picture day. I'll take one.

Thanks. LMK.

The one I have access to happens to be gas so thats good. Looks like @WarDamnEagle might have a patch for me. if not, fabricating a piece with the outer bend near the fender lip might be a bit of a challenge.

Coffee and cars today and Halloween

Yes, thats the part I need. Thanks-

Does anyone have one of these ?

So you're saying there's a chance you have one?

I have access to a MIG welder and have a grinder.

Might need a bend break too , or access to one...

You think one of the cheap flux core MIGs would work? 125 Amp Easy Flux-Core Inverter Welder, 120V, 3/16 in. Capacity, 15 lb. -...

Did it mention PO being color blind? Asking for a friend :D