Guys, here's his response...
Mark,
Thank you for the drawing. It unfortunately illustrates what I was afraid of. We can produce corner radii on our window frames of either 2.5” or 3”. We also do not offer a combination of those two on the same frame, so it is either all 2.5” or all 3”...
I think this is good for an initial round w/the manufacturer. I cleaned-up and cropped the image(see below) and sent it over, adding that if need be, we could trace it directly onto something firm and send to them. But I think it's great for now, Thanks.
Thinking ahead, and in an attempt to minimize the back and forth w/the manufacturer, are you able to place something firm against that window opening and trace it all the way around? Adding the measurements to the full shape?
Thanks for this extra work btw.
I can reach out to the owner to discuss a group discount option. The first step is to trace the window opening onto chip board or something more rigid than cardboard for them to use as a template.
I realize we all have different model/years, but do any of you have an opening without a window in...