Recent content by ThatGillyGuy

Usually I’m all about going right by the book, but money’s tight and this was the easiest way to get through the rest of a Maine winter.

I ended up settling on a two inch just to be on the safer side of things, I’m just cheap at the moment and $100 on spacers was easier to bite than $400 on wheels

Thank you for the input, the spacers were cheaper than wheels and have the right bore diameter as far as I could tell. Basically the spacers were to correct the wheels off the 08 having too small of a bore on them to work.

So I am eyeballing a set of 1.5” wheel spacers with a 108mm hub bore. Research says these will fit (hopefully). Now they aren’t hub centric but I have a plan for that. I also have a set of 08 Silverado rims with brand new general grabber a/t2’s on them. The plan is, install spacers, install...

I ordered the AT Warden 10-ply. The roads I hunt on aren't the best, a lot of sharp ledge up here that slices just about everything. Also, thanks for al the info. Hoping I can pull all of this off in the next month or so!

I've been creeping this forum for a while but still can't find the answer I need, so here's my first post! I recently bought a '97 LX450 with 233,000 that's bone stock. I'm looking at two inch lift springs as mine are sagging pretty good. Is it possible to sneak by with Monroe shocks and two...