Sounds like incredible advice. I will definitely measure everything beforehand. I’ve already found out that wire wheels aren’t going to cut it. I’m not sure if there is a sandblaster in my area so I may have it chemically dipped.
That’s what I was thinking. First I have to repair the cowl assembly. The toe boards are pretty bad and the bottoms of the cowls are rusty. Once I get that done I’ll do the outer rockers and then the front floor. Quarters and rear sill after that.
I see what you’re saying. I think that is the way to go. I have a ton of rust so that’s my plan. The only parts I’m reusing are the cowl assembly, the b pillars and the hat channels on the top of the quarter panels.
Wow! I’m impressed. That inspires me to jump into this thing. I’ll get some photos of what I have so in the disassembly of the truck. Did you brace everything beforehand?
I watch a lot of those too. Japhands is a great channel. I definitely agree that making anything from scratch is going to be way harder. I think when I do floors, since I have the complete front and rear floors that’s what I’ll do. I’m sure cutting and fitting will be involved. I’ll post...
Hi everyone. It’s been a long time since I was here. I’ve finally got to a point where I can get started on my 79 FJ40. I have most of the body panels I need I think. I plan on replacing floorboards, rockers and quarters. I’m thinking rockers first and working my way back. After bracing the...
Man, really sorry to hear about losing your Lab. It’s tough for sure. You get so attached. Leaves a hole. Way to focus all that emotion though . You got a ton done! I’m impressed! And inspired!