Recent content by spencergonomo

  1. spencergonomo

    Misfire/rough running 80 series

    Another update: pulled the O2 sensor and now it revs freely—the cats are clogged. However #6 still has a consistent misfire and it throws a p0306. Bit the bullet and pulled the fuel injectors - tested #6 and it was clearly clogged. Cleaned it with carb cleaner and 12v power supply, reinstalled...
  2. spencergonomo

    Misfire/rough running 80 series

    Update: Still having the same issue—the most characteristic symptom is the engine not revving past ~1900RPM. Sounds like a random misfire when on throttle whereas idle sounds like a consistent misfire on #6. Finally threw a P0306 code. Checked so far: Spark (looks strong on all cylinders)...
  3. spencergonomo

    Misfire/rough running 80 series

    The connector seems to be fine, and I can hear the injector ticking when I put my ear up to a screwdriver touching it. would the truck run at all if it was 180° out? I am almost sure I set it at the correct TDC but will surely double check that. I seem to be getting the same voltage reading to...
  4. spencergonomo

    Misfire/rough running 80 series

    I just finished a head gasket on my 1997 80 series and I started it up and it runs very rough. Pulling spark plug boots, I found no change to the idle on cylinder 6. I have no check engine light (should this throw one?) I confirmed I have good spark and I can hear the #6 injector firing, the...
  5. spencergonomo

    Rust on cams after sitting with milkshake oil

    Beautifully said. Thanks for the perspective—I am going to continue with the head gasket job. It's better this truck gets cleaned up and on the road rather than sitting in the woods for another 5 years waiting for a full rebuild.
  6. spencergonomo

    Rust on cams after sitting with milkshake oil

    Thanks for the replies. Sent my borescope down the spark plug holes today. For the most part they looked perfect, but I've attached the worst spots—the one that looks pretty bad was cylinder #1 in the third photo. I guess its hard to gauge without pulling the head and feeling the walls with a...
  7. spencergonomo

    Rust on cams after sitting with milkshake oil

    Hello, I am new here, so apologies if I am posting in the wrong spot. My brother purchased a '97 collectors edition Landcruiser a few years ago with a blown head gasket with hopes of fixing it, but it ended up sitting outside for the past 3 or so years. This weekend I pulled the valve cover in...
Back
Top Bottom