Recent content by SkidBro

  1. S

    1HDT BEB and/or Crank main thread

    As the title states, what BEB and/or crank main bearings are you using? how has the longevity of them been and have you had any issues? id love to see all your experiences compiled into a single thread. I'm working through a rebuild of my 1HDT.. Tri-metal Duraglide made by ACL seem to be my...
  2. S

    Cracked valve stems :o

    The cracks in these photos are all of the same side of the stem, on cylinder 4 intake. The crack starts from the top and travels down to the bottom. It spiders out in the center. I can't help but suspect the stem and/or valve guide is worn.. allowing the stem to flex, causing these cracks...
  3. S

    Cracked valve stems :o

    Hi Fam I'm currently in the process of rebuilding my 1HDT. The engine seems to have had a hard life in it's 380thou k life time. Cylinders require machining oversize, crank requires undersizing and the cam bearing journels (#2-#7) are out of spec, according to the FSM. Anywho, back to the...
  4. S

    Individual main bearing damage 1HD-T

    I'm going to bump this thread.. I have the same bearing damge on my main crank bearing, First main bearing on front of block (not Conrod). I just measured the crank and found the shaft that runs in this bearing to be 1 micron under bottom tolerance. Crank shaft regrind was going to be the next...
Back
Top Bottom