Recent content by sheeeep

Cant help with the transgo kit, but regarding the switch, I bought my switch from Switchboss in Aussie, matches the stock prado switch, and works well. Looks like toyota put it there if youre searching for a switch, in my 90 it sits next to where the shifter is in an unused hole

Massive thank you to Alex. The ECU pinout was correct, verified it by going for a drive with the multimeter pushed into the plug. System works great and is absolutely fool proof when in operation. Thanks again!

Me again, sorry, im not much of an electrical guy so im struggling a little I have built my harness and box, and am ready for the last two terminations, my two questions Based on your diagram above for the ECU pinout, on the KZJ95 SL would be the solenoid lock up right? Pin C1. I ask as there...

Thanks! I have built mine into a small box, with a deutch connector so i can remove it easily if needed. Only other question I have, is around the Diode. based on the diagram, I cut the wire to the solonoid and put the diode in, then connect the wire from the relay to the solonoid wire and...

Thank you for the write up, I have done a similar mod in the past on my Surf, but haven't done it to my prado as I don't like the stalling if you forget to switch it off, and this setup eliminates that. I have ordered an OE looking momentary switch for my 90, and will build a small box to house...