Recent content by schmidtchen98

So the 80 is at the shop today to get the new U-Joints pressed in and the DS rebalanced as i dont think the weights on it are doing good work right now after i changed the allingement on them. Will report later how it turned out. So the next big thing is the front axle. As i said, when i go...

So.. it was the rear DS. Changed the Phase to in phase - that heavy vibration is gone! Rear U joint is still gone and the front Yoke has a little bit of play. But right now it’s definitely drivable!! On Monday the U joints and then we will see again. Got broken CV’s as well I think. When...

So I just double checked it and… …they are both not in line.. The front one ist not at 90 degrees neither is the back parallel. Iam will try to correct both tomorrow to see if it gets better. But the U Joints of the rear DS are definitely loose as well. Also: How much play is the rear...

Sorry forgot the details: HDJ80 260000 km - 150 isch miles late 1992 Automatic transmission tripple locked left hand drive on 35´s with an 3 inch lift 2° caster correction

Hey Guys, sorry for the delayed feed back. here are pictures of my front and rear DS... If I remember it right, the front has to be out of phase and the rear one in phase right? Because my rear ist out of phase as well. Havent noticed it until you guys told me to take some pictures... In...

The Splines were all good, no play at all. But the pull out ist visible. Greased the rear one today as well, but no change before the test drive this afternoon..

Hey Guys! First of all thanks a lot for all the replies and the great advice! I’ve pulled the front DS today and went for a drive (thanks for the mod 7 tip Marlin!) The vibrations were definitely a bit less. But just less… As I was coming back, I „parked“ the 80 on an even surface in...

Hi Marlin! Thank you! I will check it for play when Iam back at home. The U Joint and the Shaft itself were greased when I lifted the truck, that should be fine. What I’ve also noticed this morning: While Iam driving, not accelerating or decelerating, and Iam going over a long strecht...

Hey Guys, iam a neubie here. Coming from a Lond Rover... mistakes were made... now Ive got the proper thing. First of all sorry for my Englisch. Iam from germany but iam trying my best :) I recently liftet my 80 series with the ome 2,5 inch lift kit. On top Ive got some 10 mil spaces on...