I used a battery terminal spray cleaner on both connector. Let it sat then cleaned it with contact cleaner afterwards. It came out really clean . Then i applied die elec. grease.
That is the connector that had water in it. Notice the back protector or sleeve? Thats where the water is at. I will disconnect it and apply die grease. Will try to put the boot back and secure it with electrical tape.
Im here again. I had the chance to look at barrel Connector that summit cruiser mentioned aboved. Anddddd bam! The shrink tubing that protects the back of the connector was full of water. Drained the water then sprayed it with air. Test drove the vehicle, runs good and 4th gear engaged smooth...