Recent content by random101

had a spare from another box. Rebuilt and all sorted :)

It was the detent spring :( Can I run without it?

Hi all, Built about 3 of these with no issue - now for some reason I’m stuffing something up. My issue (with a spare case apart as well). The low select goes slightly too far overshooting the fork (I have this issue in the car atm) I pulled it apart and put it back together thinking I fixed...

Should update to say. Fixed - was the connector into the controller being loose

Hi all, I’m looking at which to put in my car an. The AISIN is a bit harder to get and also more expensive. I ordered the YSK thinking it was the same. But the pumps are slightly different. North Vic engines say the pumps slightly larger than the FTE which I’d believe when comparing the two...

Hi all, I don’t have the wiring diagram for my 1hdft cruise control (fixed, wasn’t plugged in properly when I replaced my CDL relay). In anycase I’m looking at going Auto with an aftermarket ecu - I digress. I need 4 inputs Brake, RPM, TPS and Boost I assume the 3 inputs going to the...

Hi all, I have two issues 1. Coolent temp seems to wonder sometimes 2. My CDL doesn’t engage. I replaced my coolent temp sensor, the gauge in the cluster and when I started it this morning after 3 weeks it worked perfectly. I went to restart it… and it did its thing but then sat back to where...

It was replaced with a brand new module - I think it’s an electrical gremlin. Just not sure where to look.

Bump again

I think there is the primary ground on the block missing - when I was looking at the connection yesterday. But I’m not sure what it grounds (just under the temp sensor) near the filter I don’t think the FSM has a wiring diagram

Hi all, Have an issue with my temp gauge. I replaced the gauge, same issue. Replaced the gauge, same issue. The issue is now the gauge doesn’t start at cold and move up to operating temp. On a cold start it goes straight to the middle (warmed up). Since replacing the gauge on...

Thanks - no shortage of threads. I couldn’t hear anything engaging so I pulled to check the relay. I either ****ed it when testing it or it was ****ed. Eitherway I’ve ordered a new one… I’m hoping it’s nothing more… Would be painful if it is. (Wiring looking like the front and rear switch...

Hi all, Did an engine swap it all worked perfect before it. I thought I tested it after but I can’t remember. Went to use it (had a part time kit, manual). And added a cdl switch for the part time kit. Anyhow it won’t come on in low range or when I push the button. Fuse is okay. I haven’t...

Oh yeah sorry my fault. Was too early morning. Fixed up. Sensor is replaced… I haven’t pulled the gauge out yet… I may try disconnecting at temp see what it does

I mention I replaced it with a brand new sensor. Same issue