Recent content by PZ LC

  1. PZ LC

    Injection pump timing

    Thanks @Eurasiaoverland I really appreciate it.
  2. PZ LC

    Injection pump timing

    Another question if you dont mind. After reinstall, my timing belt is running a little of center of my pulley which I don't love. I centered it all up before starting and as soon as the engine runs it shifts over that couple mms. The belt and tensioner are about 18 months old and roughly 18...
  3. PZ LC

    Injection pump timing

    Well, I got it sorted. I'm not exactly sure where my problem was but I suspect it may have been with tool setup as you suggested. That night I decided to put down the tools and, pick up a beer and revisit the next day. I removed the tool and gauge, restarted the procedure from step one...
  4. PZ LC

    Injection pump timing

    Yes I'm certain they are all aligned at TDC. The marks are obvious. And I am aware thay there are separate marks for BDC for setting up the timing belt. I could take it back but unfortunately I live fairly remote so it would be 2 ferries and almost an all day affair to go back so im.hoping to...
  5. PZ LC

    Injection pump timing

    I just had my IP rebuilt on my 1PZ. I ordered the special tool and trying to get it timed correctly. The plunger stroke for the 1PZ is 0.82 - 0.88. To achieve.0.85mm I'm having to set the pump advanced far enough that I'm running to the limit of the adjustment in the slotted holes in the pump...
  6. PZ LC

    Wanted 1PZ exhaust manifold

    Searching for an exhaust manifold for a 1pz turbo build. I have aftermarket long tube headers that won't suit my turbo build. Also looking for a CT26 turbo Thanks in advance.
  7. PZ LC

    Introduction from the PNW

    Hey fellas, have been lurning here for 15 years or so after owning various 4x4s, have gone from a Sidekick, pajero, Tacoma, 4runner Nissan Atlas etc etc I finally got the dream unit. A really clean single owner unit from Japan. After years of gathering info here I figure it's time to start...
Back
Top Bottom