Recent content by ProbablyTheGuy

An update, I let my mechanic friend borrow it this last week to move some stuff. He and I then played with it in the garage and trouble shooting we found that the harnesses were backwards. Swapped the pins and it now works. I still need to pump the torsion bars up for the pressure is high but...

Ok, we're getting somewhere, I replaced the wire harness from the sensor to the engine bay with the new one and the plug just fell out in the engine bay easily. The truck then cycled the suspension and is now stuck in Low and will just flash the selected height indefinitely. I had two codes...

Ok, we're getting somewhere, I replaced the wire harness from the sensor to the engine bay with the new one and the plug just fell out in the engine bay easily. The truck then cycled the suspension and is now stuck in Low and will just flash the selected height indefinitely. I had two codes...

Ok I cleared it after unplugging and replugging. No DTC's FR Height Sensor -6.3 FL Height Sensor 0.1 RR Height Sensor 0.1 Front Pressure 5.1 Rear Pressure 4.4 I have no idea how toget the right sensor to read 6.3 inches higher than it is. Truck is not leaning that way at all.

Good news, sensor showed up today, I put it in and matched the physical height to the other side. Still flashing off on the drive home. Plugged it into techstream and I have a C1711 code that wont go away on the clear. Gonna check the connection again.

Thanks, yeah sensor is in the way. Should be here by the 27th. Will update after it’s on.

I figured that was the case. Thank you. I have seen it but since I cannot use my up or down buttons yet, I figured it wasn’t time to turn my reading comprehension switch yet on it. Plan on printing out some tomorrow.

Front right ordered, I couldn’t get them close to 0. The front left was already adjusted all the way up. Should I be concerned that the rear is not reading any pressure other than -0.2 yet?

When the front pumps up after start, it raises, drops, then raises again and I have a very comical Tennessee tilt going on like it wants to fit in with the diesel trucks. Thanks for helping and talking me through this.

Ok I can get that going the heim joint on the passenger side is looking crusty and wiggles easily. also to be noted, I’m told this thing has Land Cruiser Torsion Bars instead of the AHC.

Rear sensor and driver front are new. It leans in the rear towards the driver but only noticed when walking towards it while parked.

Ok so, if I can get half of my front pressure to go to the rear we’d be great.

That checks out, I can imagine noone has done much to this poor thing. Also why I got it for so cheap. I'll pull the AHC stuff when I get home.

Just checked #40 and 41fuse. Looks old and dark but not blown.

Ok so long story short, I finally got techstream working to see why my AHC isn't doing anything but blinking OFF in Neutral. I do a health check because I'm an idiot and don't know what I'm doing but then get the following ABS/VSC/TRAC DTC codes: C0278 C1223 C1224 C1241 C1268 C1340 I clear em...